TMC-212TM User's Guide - Reinders.com

MANUALOutdoor Model InstallationONONMANUAL STARTSTARTBNEXTNEXTOFFOFFCADEFGPreparing the Cabinet for Installation1. Remove the lower housing cover (A) by pullingoutward on the handle.2. Remove two phillips screws from the transformeraccess cover (B). Pull the cover outward from thebottom to remove.3. Three lower mounting holes (C) are provided. Thecenter hole is open and the outer holes are plugged.If you intend to use the outer holes for installation,carefully drill through the plugs with a 3/16" (5mm)drill bit.Four wiring access holes are provided in the cabinetbase as follows:(D) - 1/2" (13mm) for power and equipment ground wires.(E) - 1/2" (13mm) (plugged) for optional Toro RainSensor wires.(F) - 3/4" (19mm) for sprinkler valve wires.(G) -1/2" (13mm) (plugged) for optional Toro remotecontrol cable.4. If planning to install the optional Toro components,remove the plugs as necessary.9