XC-IS22CD M-IS22 S-IS22 - Service.pioneer-eur.com - Pioneer
XC-IS22CD M-IS22 S-IS22 - Service.pioneer-eur.com - Pioneer
XC-IS22CD M-IS22 S-IS22 - Service.pioneer-eur.com - Pioneer
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
10<br />
Additional information<br />
Troubleshooting<br />
Problem<br />
General<br />
No sound<br />
Can’t switch between functions<br />
Timer doesn’t work<br />
Remote control doesn’t work<br />
Power doesn’t <strong>com</strong>e on<br />
CD player<br />
CD won’t play<br />
Tuner<br />
Can’t tune into any radio stations<br />
or sound is distorted<br />
A stereo broadcast is played in<br />
mono<br />
Tape deck<br />
Can’t record<br />
Recordings are muddy or<br />
distorted, or you can still hear a<br />
previous recording under the new<br />
one<br />
Excessive tape hiss and overemphasized<br />
high frequencies<br />
Dull, muffled sound<br />
Recording made from the LINE 1<br />
input are distorted<br />
Recording made from the LINE 1<br />
input very quiet<br />
Remedy<br />
• Check that speakers and other system <strong>com</strong>ponents are properly connected.<br />
• Check that the input selector is set correctly.<br />
• If the cassette deck is currently recording, you can’t change the function.<br />
• Make sure that the clock is set.<br />
• Try replacing the batteries<br />
• If a fluorescent lamp is near the remote sensor on the main unit, it can interfere with<br />
remote operation.<br />
• Make sure that you’re using the remote within its operating range.<br />
• Check that system cables are connected properly.<br />
• Check that the CD is loaded the right way (label side should be face out).<br />
• Check that the CD is clean and free of scratches and other damage.<br />
• Check that the function is set to CD.<br />
• Check that the antenna is properly connected.<br />
• Experiment with the placement of the antenna.<br />
• Make sure that other electrical appliances (fluorescent light, hairdryer, etc.) are not being<br />
used closeby.<br />
• Check that the tuning frequency interval is set correctly for your region/country.<br />
• If the mono indicator is lit, press MONO to switch it off.<br />
• Check that the tape you want to record on still has the erase-protect tabs in place, or that<br />
they are covered with tape, etc.<br />
• Clean the tape heads.<br />
• Make sure that Dolby NR is in the same position as when the tape was recorded.<br />
• Make sure that Dolby NR is in the same position as when the tape was recorded.<br />
• Set the LINE 1 input level to ATT ON.<br />
• Set the LINE 1 input level to ATT OFF.<br />
42<br />
En