F11N F13N - Belmet
F11N F13N - Belmet
F11N F13N - Belmet
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Meaning of the symbol<br />
Warning ! Please refer to the User’s Manual before using<br />
the instrument.<br />
In this User’s Manual, the instructions preceded by the<br />
above symbol, should they not be carried out as shown,<br />
can result in a physical accident or damage the instrument<br />
and the installations.<br />
Meaning of the symbol<br />
This equipment is protected by double or reinforced<br />
insulation. It does not require connection to the protective<br />
earth terminal to ensure electrical safety.<br />
You have just purchased an <strong>F11N</strong> or <strong>F13N</strong> multimeter clamp<br />
and we thank you for your confidence. To obtain the best<br />
possible service from your equipment:<br />
- read these operating instructions carefully,<br />
- respect the precautions for use.<br />
PRECAUTIONS FOR USE<br />
■ Make sure that the conductor is correctly aligned in relation<br />
to the markers and that the clamp is properly closed.<br />
■ This clamp can be used in category-III installations with<br />
voltages of less than 600 V in relation to the earth.<br />
■ Category III meets the severe reliability and availability<br />
requirements corresponding to constant use on fixed<br />
industrial installations (cf. IEC 664-1).<br />
■ Do not use the clamp for currents greater than 1,000 A.<br />
Limit the measurement time for currents between 700 A<br />
and 1,000 A.<br />
■ Make sure that the switch and, if necessary, the leads are<br />
positioned correctly before making any measurements.<br />
■ Always disconnect the leads from the clamp when<br />
measuring the current.<br />
■ Always disconnect the clamp from all sources of electricity<br />
before changing the battery.<br />
■ Do not carry out any resistance measurements, continuity<br />
tests or diode tests on a live circuit.<br />
■ Set the switch to OFF when you are not using the clamp.<br />
14