SupraMatic E P 9 Notice - Hormann.fr

ENGLISH6 Trouble-shootingDisplay Fault/Error Possible cause RemedyLearned force limit Required force for tuning Check door actiontoo highprocess was ≥ 350 NDoor movement extremely sluggish Disengage operator. It must be possibleto easily operate the door by handEntry not In menu 4 value equals zero In menu 3 it is only possible to set thepossibleautomatic timer if the closing edgesafety device (SKS) and photocell (LS)are activated in menu 4 beforehand.Excess travel Belt torn Replace the beltstopOperator defectiveReplace the operatorOverload current Internal error Retune the operator,if necessary replaceForce limit Door too sluggish Correct door movementObstruction in door areaRemove obstruction;If necessary, retune the operatorStatic current Terminal 12, 13 open Bridge terminal 12, 13circuitOFF-switch openClose OFF-switchRPM Springs incorrectly Correct spring tensiontensioned(caution!)Springs brokenHave springs replaced by thegarage door's service engineersPhotocell Light path interrupted Set the photocellPhotocell defectiveReplace the photocellClosing edge Photocell interrupted Check transmitter and receiver,safety deviceif necessary replace or completelyreplace the closing edge safetydeviceNo reference Power failure Move door to OPEN travel limitpointOperator not Operator not yet set Set the operator limitsyet setDoor is at the OPEN Door is at the inter- Door is at the CLOSED Impulse input (radio,end-of-travel postion mediate position (half end-of-travel postion button) acknowledgedopen)54 05.2004 TR10A011 RE