KM 90/45 R - Kärcher

machine was secured on a
The
with stretch belts or ropes for
pallet
as follows when unloading:
Proceed
Cut the plastic packing tape and
Detach the identified planks from
timber base and use them as
the
driving-down ramp
the
The provided screws can be
to secure the ramp
used
The timber from the rear end of
timber base is used as a
the
(1) for the ramp
support
Mount/adjust handlebar
—
Mount the side broom
—
Install the batteries
—
Charge the batteries
—
Connect connecting wire to
—
(applies to Package
battery
version)
maintenance tasks chapter for
See
description
Stand sweeper on a flat surface
Set key switch to "0"
Raise main brush and side
brushes
and maintenance
Testing
work
Clean-down the dust filter
Empty the swept material
container
Check the side brush
maintenance tasks chapter for
See
description
the battery charge
Check
state
The red LED starts to flash when
battery capacity drops.
the
From that moment sweeping is
—
only for a few more
possible
minutes.
The battery is drained and must
recharged when the red LED
be
Note:
unit is provided with a deep-
The
protection.
discharge
sweeping units and the suction
The
are switched off if the
turbine
capacity minimum is still
permissible
attained.
then on only driving is
From
maintenance tasks chapter for
See
description
Warning!
unit may be operated only if the
The
cover and all other covers are
unit
closed.
Sit in the driver’s seat
Do NOT actuate the drive pedal
Note:
machine cannot be started if
The
drive pedal is depressed prior to
the
as the key switch is actuated.
or
the sweep roller
Raise
Pull the lever upwards and
the side broom
Raise
Depress rear of pedal until it
Operating instructions KM 90/45 R English
Before first operating
Initial fitting
Commissioning
Unloading instructions
safe transport.
remove the film.
Key switch set to "1"
Before every operation
Run machine
General notes
Battery charge indicator
engage it
flashes continuously.
Check the sweep roller
Key switch set to "1"
Timber ledge for support
possible.
engages
22