29.09.2014 Views

BILSTEREO AUTOSTEREO - Biltema

BILSTEREO AUTOSTEREO - Biltema

BILSTEREO AUTOSTEREO - Biltema

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

DIN FRONT-MOUNT (Method A)<br />

Installation Opening<br />

Frontmontering (metod A)<br />

This Denna unit enhet can kan be frontmonteras installed in i alla any instrumentbrädor<br />

som har it en out öppning to remove enligt bilden it.<br />

dashboard<br />

having nedan: an opening as shown below:<br />

it would<br />

such as<br />

hot air,<br />

ould be<br />

xcessive<br />

Försäkra dig först om att alla anslutningar är<br />

korrekt utförda och följ sedan följande steg:<br />

Art. 24-666<br />

Installing the unit<br />

left and right sides of höljet. the Lossa unit. höljet Then genom slide att trycka det<br />

Be sure<br />

1. Kontrollera<br />

you test<br />

att tändningen<br />

all connections<br />

är avslagen och<br />

first, and bakåt med hjälp av nycklarna.<br />

koppla loss bilbatteriets minuspol.<br />

ither then2. follow Koppla these loss kabelhärvan<br />

the<br />

steps<br />

sleeve INSTALLATION<br />

to och install antennen<br />

off<br />

the<br />

the<br />

unit.<br />

back of the unit.<br />

från enheten.<br />

t-mount) 1. Make sure the ignition 6. Mount is turned Sleeve 3. the Hölje<br />

off, sleeve and by inserting the sleeve<br />

4. Vänster L<br />

ion, then disconnect the into Keynyckel<br />

cable the from opening the of the dashboard and<br />

Outer 2. Trim Sarg Ring<br />

vehicle battery’s negative bend (-) open terminal. the tabs located around the<br />

2. Disconnect<br />

Front 1. Frontpanel<br />

the<br />

Panel<br />

wire harness and the<br />

r to the<br />

sleeve with a screwdriver. Not all tabs<br />

antenna. will be able to make contact, so<br />

3. Press the release button on the front<br />

examine which ones will be most<br />

panel and remove the control panel<br />

effective. Bending open the appropriate<br />

(see the steps of “removing the5. R front Höger Key nyckel<br />

panel”).<br />

tabs behind the dashboard to secure<br />

4. Lift the top of the outer the trim sleeve ring then in place. pull<br />

it out to 3remove it.<br />

Dashboard<br />

1. Instrumentbräda<br />

5. The two supplied keys release tabs<br />

inside the unit’s sleeve so you can<br />

Tabs<br />

2. Flik/spärr<br />

remove it. Insert the keys as far as<br />

e sides<br />

hods.<br />

(see the steps of “removing the front<br />

panel”).<br />

4. Lift the top of the outer trim ring then pull<br />

5. The two supplied keys release tabs<br />

inside the 53mm unit’s sleeve den. so you can<br />

remove it. Insert the keys as far as<br />

182mm<br />

they will go (with the notches facing up)<br />

into the appropriate slots at the middle<br />

they will go (with the notches facing up)<br />

into the appropriate slots Screwdriver<br />

3. Skruvmejsel<br />

at the middle<br />

left 6. and Montera right höljet sides genom of att the försiktigt unit. passa Then in slide<br />

det i instrumentbrädans öppning och böj ut<br />

the sleeve metallflikarna off med the en back skruvmejsel. of the Troligen unit.<br />

3. Tryck på frontpanelens releaseknapp och<br />

lossa panelen (för närmare detaljer, se<br />

avsnittet ’Att använda den löstagbara frontpanelen’).<br />

4. Ta tag i toppsidan av sargen, lyft den försiktigt<br />

uppåt och drag sedan utåt för att lossa<br />

5. De två medföljande metallnycklarna används<br />

för att lossa enheten från höljet. För<br />

in nycklarna, med märkningen pekande<br />

uppåt, i de smala hål som finns i mitten av<br />

höljets höger och vänsterkanter (se illustration).<br />

Genom att trycka in nycklarna så lossar<br />

du de två metallspärrar som håller fast<br />

kommer inte alla flikar att vara användbara<br />

för att låsa höljet, Sleeveså kontrollera vilka flikar<br />

som L lämpar Key sig bäst och säkra höljet med<br />

Sleeve 4. Hölje<br />

Outer Trim hjälp Ringav dessa.<br />

Front Panel<br />

7. Reconnect 3the wire harness and the<br />

© 2013-02-15 <strong>Biltema</strong> Nordic Services AB<br />

10.<br />

te<br />

Rem<br />

1. M

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!