QUIRLI - Green Hobby & Model
QUIRLI - Green Hobby & Model
QUIRLI - Green Hobby & Model
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
The wheel spats can now be fitted on the axles together with the wheels; note that a<br />
wooden disc has to be fitted on each side of each wheel. Fix the wheel spats to the<br />
undercarriage legs, gluing the plastic saddle clamps in place at the same time. Check<br />
the alignment of the spats before gluing them: the centreline of the moulding should<br />
be at right-angles to the undercarriage leg.<br />
Allow the glue to set hard, then tack the wooden discs to the wheel axles to centre<br />
the wheels in the spats.<br />
The next step is to install the motor mount assembly; place the fuselage on the<br />
undercarriage for this stage. Fix the motor to the motor bulkhead using the screws<br />
supplied with the motor, as shown in the photo.<br />
Insert the lugs on the motor mount assembly in the slots in the nose bulkhead, and<br />
check that the parts fit snugly: there must be no gaps between the motor mount and<br />
the nose bulkhead. Glue the parts together securely.<br />
The speed controller should be installed under the battery plate using Velcro tape.<br />
Slip the cowl over the nose of the fuselage from the front.<br />
To align the cowl properly it is necessary to fit the spinner backplate on the motor<br />
shaft. Position the cowl accurately, then attach it to the fuselage using tape or four<br />
self-tapping screws.<br />
Assembling the <strong>QUIRLI</strong><br />
We recommend that you connect two 100 mm extension leads permanently to the<br />
appropriate receiver sockets (2 and 5), as this makes it much easier to connect the<br />
aileron servos when assembling the model.<br />
Connect the aileron servos to the extension leads, slip the wing joiner tube through<br />
the fuselage, and slide both wing panels onto the tube. Fit the four self-tapping<br />
screws to prevent the wings coming adrift, as shown in the photo.<br />
Attach the flight battery to the mounting plate using rubber bands as shown.<br />
Engage the lug on the mounting plate in the slot, and fit a self-tapping screw at the<br />
rear to secure it.<br />
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY<br />
Änderungen vorbehalten! Keine Haftung für Druckfehler 12/2006<br />
34