Ditec Smart Plus - DITEC ENTREMATIC

47EAlways cut the jumper J2 on door Ditec Smart PlusENCNT+F -F U V W1716ON1GNDU24ON1312T5T6LNJ1J215OFF 1 2 3 411 10 9 8 7 6 5 4 3 2 114DLT3T1T4T2F1F21 11 12 1341 40 20 9 8 4 3 2 1 1 0 LAMP230 V 50/60 HzFUSESID Value Dimension CircuitF1 - F2 12A - 500V 10.3 x 38 monophase lineADJUSTment limit switchCBAdjusting the limit switch1. Set the deceleration ramps to zero. (T5 - T6)2. Calibrate the limit switch (C) on the gearmotor so the door stops approximately200-300mm from the closure point.3. Calibrate the opening limit switch (A) at the opening point.4. Calibrate slowdown limit switch (B) in such a way that it engages atapproximately ¾ of the opening stroke.5. Calibrate the opening speeds using trimmer (T3) and closure (T4).6. Calibrate the opening (T5) and closure (T6) trimmers of the decelerationramps in such a way as to cause stopping in the actual door open and doorclosed positions.C300AAB¾TROUBLESHOOTINGCOMMAND TROUBLE VERIFYEvery command, in everycurtain positionThe curtain and the motorsdon’t move• Control unit test was failed(led 13 green OFF, led 14 red ON)Opening CommandDuring the closingmovementThe motor run with slog orit doesn’t reach to the rightspeed (the brake wasn’tactivated)The motors doesn’t madedeceleration ramp• See the bridge J2 it must be cut• Adjustment of the closing limit switch (C) at 300 mm fromthe floor• Adjustment of the deceleration ramp by means the trimmer T6NB for general diagnostics see also at page. 43- 41 - 0DT826 2013-07-01