Montage- und Bedienungsanleitung Funk-Wandthermostat ... - ELV

Press the "OK" button to call up the information on the sensors.
The window symbol and the window position ("OPE" or "CLO")
are shown on the display. If the battery is low, the battery symbol
will also be shown. If the radio connection between the sensor
and the controller is interrupted, the antenna symbols will also
flash. Use the setting dial to switch between the taught sensors.
8.5 Teaching and unteaching of devices "KON"
After selecting this menu point, the new device can be taught to
the heating controller or devices that have already been taught
can be untaught.
Call up special function "KON".
Press the "OK" button.
Now, choose whether you want to teach or unteach with the
setting dial:
Teach ("ADD")
The device is now in teach mode for approx. 20 seconds. If a
component has been taught successfully during this time, "OK"
appears on the display.
Unteaching ("DEL")
Unteaching is only possible if the room thermostat has not be
taught on a center station.
Use the setting dial to select the components that should be
untaught. Valve drives are only shown by their device number on
the display, shutter contacts or door window rotary handle sen-
52