FLAIL MOWERS PRE-OPERATION Inspection - McConnel
FLAIL MOWERS PRE-OPERATION Inspection - McConnel
FLAIL MOWERS PRE-OPERATION Inspection - McConnel
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
GEARBOX LUBRICATION<br />
The photos opposite shows the lubrication<br />
access points for the gearbox and half-shaft –<br />
lubricant level should be checked on a daily<br />
basis during work and topped up only if<br />
required.<br />
Checking of the lubricant level is performed<br />
by removal the level plug on the half-shaft –<br />
the lubricant should be inline wit h the bottom<br />
of the plug aperture. ‘Topping up’ of the<br />
lubricant is performed via the filler plugs<br />
(shown opposite) to a point where the oil<br />
starts to ‘dribb le’ out of the level p lug.<br />
Replace and tighten all plugs before using the<br />
machine.<br />
Gearbox and half-sha ft lubricant should be<br />
replaced annually.<br />
The drain plug for changing the lubric ant is<br />
located on the botto m of the gearbox as<br />
indicated in the photo opposite.<br />
Capacity & Lubricant Type<br />
2.0 Litres - SAE90<br />
<strong>FLAIL</strong> REPLACEMENT<br />
The rotor and flails s hould be inspected for wear or damage on a regular basis – missing,<br />
damaged or worn flails should be replac ed immediately. When replacing a flail the<br />
diametrically opposite flail should also be replaced at the same time in order to maintain<br />
rotor balance.<br />
DANGER: Machine and tractor should be switched off and the starting key removed at all times when<br />
inspecting or maintaining the machine – Never work on a machine that is switch on and running.<br />
Always replace flails in opposing pairs<br />
ROTOR VIBRATION<br />
If vibration of the rotor is experienced the ma chine should be stopped immediately – this is<br />
often a sign that a flail is eit her missing or severely damaged, if this is the case do not us e<br />
the machine until the problem ha s been rectified. If vi bration continues, or occurs for no<br />
apparent reason, the rotor must be checked and, if necessary, rebalanced before using<br />
the machine again. Contact your local dealer for further advice or assistance on this<br />
subject.<br />
17