Comfort 250, 252 - Marantec

More documents

Recommendations

Info

D. Installation 1 Preparation • Unpack the boom and the motor unit and keep it ready for mounting. 2 Required tools Combination wrench SW 10 Combination wrench SW 13 Socket wrench SW 8 Socket wrench SW 10 Socket wrench SW 13 Screw driver, size 5 Screw driver, size 8 Phillips Screw driver, size 2 3 English Page 8 Masonry drill ø 6 mm Masonry drill ø 10 mm Metal drill ø 5 mm Pliers Hack saw Electric drill Electric drill Attention! Before drilling, cover the motor unit with foil or cardboard. Drilling dust and chippings can lead to malfunctions. Site requirements • Please suspend the motor unit together with the boom in such a way, that the upper door edge lies approx. 10 mm below the downward horizontal boom edge- measured at the highest point of the opening course (see points 8, 9 and 10). • Mount the unit to the ceiling according to the site requirements. Please observe as well the indicated measurements for wall plug drilling.
D. Installation 4 Connect boom with the operator unit • Push the adapter sleeve (A) to the stop onto the fine toothed gear shaft (fig. D.3). If you turn the operator unit by 90°, the installation depth is lessened by 150 mm. For this the reference point switch (B) has to be turned as well to the foreseen position (fig. D.4). • Put the boom in its right position to the adapter sleeve. • Align the boom laterally. • Push the boom onto the operator unit using slight pressure (fig. D.5). Attention! Do not use force! If the boom is aligned parallel to the surface of the operator unit, a short pull on the carriage is sufficient to lower the boom onto the operator unit without force. • Screw the boom to the operator unit using two clamp brackets (C) and four hex screws SW 8 (D) (fig. D.6). 5 Mount suspension clamp to boom • Mount the suspension clamp to the boom (for function and position of the suspension clamp please look up point 3). English Page 9 GB GB
Page 1 and 2: Comfort 250, 252 Operator System fo
Page 3 and 4: A. Contents A. Contents............
Page 5 and 6: B. Meaning of symbols Symbols of co
Page 7: C. Important safety advice • All
Page 11 and 12: D. Installation • Connect two doo
Page 13 and 14: D. Installation • Screw the linte
Page 15 and 16: D. Installation 13 Advice! Bulbs ar
Page 17 and 18: E. Hand transmitter 14 Hand transmi
Page 19 and 20: E. Hand transmitter Advice! For mul
Page 21 and 22: F. Control unit connections 17 Conn
Page 23 and 24: G. Display functions and programmin
Page 59 and 60:
G. Display functions and programmin
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
H. Test instructions Remedies • C
Page 81 and 82:
J. Initial operation and maintenanc
Page 83 and 84:
L. Index of illustrations Fig. D.1:
Page 85 and 86:
Produkt product produit Angewandte
Page 87 and 88:
Produkt product produit Einschlägi
show all

Comfort 250, 252 - Marantec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?