Comfort 211 accu / solar - Marantec

8. Initial operation
8.5 Express programming
8.5.1 General notes on express programming
Attention!
When programming the end positions
the mechanical end position must not
be touched because otherwise the fuse
in the charge regulator will be activated.
For proper initial operation of the operator,
three basic operator functions must be set using
express programming:
- End position DOOR OPEN
- End position DOOR CLOSED
- Remote control programming
This programming procedure is carried out consecutively
and is compulsory.
Following express programming and a test run of the
OPEN and CLOSED functions, the operator system is
ready for use.
Advice:
Additional operator functions can
be set using the expanded operator
functions.
Important factory default settings can
be changed there.
This programming may only be carried
out by specialist personnel.
8.5.2 Programming buttons
8.5.2 / 1
The P programming button is pressed using the
enclosed programming pin (A).
The programming is carried out using the plus (+),
minus (-) und P buttons.
If no buttons are pressed within 120 seconds
while in programming mode, the control unit
reverts back to operating mode.
A corresponding message appears in the display.
Reference:
The messages are explained in
Chapter 10.
Legend:
LED off
LED flashes
LED flashes slowly
LED pulses
LED flashes quickly
Factory default setting
Not possible –
34 Manual for installation and operation, Comfort 211 accu / solar GB (#73385)
i
A