TECHNICAL SERVICE MANUAL PRIMEA LINE 2007

More documents

Recommendations

Info

7.14 Grinding adjustment REV. 00 - Mar. 07 + - Remove the screw from the door To adjust grinding, press on the element with a hex key. (+) = Coarse ground. (-) = Finely ground. WARNING: - Grinder must be adjusted with the motor stationary. - Adjust the grinding level by one step at a time. - After completing settings, start the coffee cycle and run two grinding cycles. - Repeat if further adjustment is required. PRIMEA 2007 Chapter 07 19/22
7.15 Autocappuccino. Withdraw the connector from the electronic board and loosen the three screws as shown. PRIMEA 2007 Chapter 07 REV. 00 - Mar. 07 20/22
Page 1 and 2:
REV. 00 - Mar. 07 TECHNICAL SERVICE
Page 3 and 4:
REV. 00 - Mar. 07 CHAPTER 1 INTRODU
Page 5 and 6:
REV. 00 - Mar. 07 CHAPTER 2 TECHNIC
Page 7 and 8:
External: Coffee bean coffee beans
Page 9 and 10:
PRIMEA 2007 Chapter 03 REV. 00 - Ma
Page 11 and 12:
Special function: Reset factory set
Page 13 and 14:
3.2 Maintenance and cleaning PRIMEA
Page 15 and 16:
PRIMEA 2007 Chapter 04 REV. 00 - Ma
Page 17 and 18:
REV. 00 - Mar. 07 Primea Touch 2/6
Page 19 and 20:
4.2 Component load table Component
Page 21 and 22: REV. 00 - Mar. 07 Primea Touch /Rin
Page 23 and 24: 2 3 4 5.1 Primea Touch Plus and Tou
Page 25 and 26: 5.1.2 Microswitch and sensor check
Page 27 and 28: Total pre-ground coffee beverages
Page 29 and 30: 5.2.5 Beverage settings REV. 00 - M
Page 31 and 32: 5.2.6 System settings PRIMEA Chapte
Page 33 and 34: 5.2.8 Auto test On selection of thi
Page 35 and 36: - CAPP_DOOR_CLOSED (milk tank door
Page 37 and 38: 5.4 Ring diagnosis function Procedu
Page 39 and 40: 5.4.4 Ring product settings SYSTEM
Page 41 and 42: Applicable models: Code Brief descr
Page 43 and 44: PRIMEA Chapter 05 REV. 00 - Mar. 07
Page 45 and 46: Two factors combine to give the fiv
Page 47 and 48: The system consists of a motor-driv
Page 49 and 50: 6.3 Motor-driven tray The movement
Page 51 and 52: 6.5 SBS valve Beverage dispensing T
Page 53 and 54: PRIMEA 2007 Chapter 07 REV. 00 - Ma
Page 55 and 56: 7.2 Right-side cover PRIMEA 2007 Ch
Page 57 and 58: 7.4 Brew unit Remove the knob with
Page 59 and 60: 7.5 Electronics PRIMEA 2007 Chapter
Page 61 and 62: REV. 00 - Mar. 07 Install the brew
Page 63 and 64: 7.7 Pump Remove the silicon tube th
Page 65 and 66: REV. 00 - Mar. 07 Remove the drain
Page 67 and 68: 7.10 Multiway valve REV. 00 - Mar.
Page 69 and 70: 7. 11 OETIKER clamp assembly and di
Page 71: 7.13 Grinder adjustment/assembly an
Page 75 and 76: Disassembling the motor-driven tray
Page 77 and 78: 8.1 Routine maintenance checklist S
Page 79: List of amendments made to manual R
show all

TECHNICAL SERVICE MANUAL PRIMEA LINE 2007

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?