9986252-DVB Satellite Receiver UFD 545 - Kathrein
9986252-DVB Satellite Receiver UFD 545 - Kathrein
9986252-DVB Satellite Receiver UFD 545 - Kathrein
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Connection and Startup<br />
Anschluss und Inbetriebnahme<br />
The following section is specifically intended for the specialist dealer. You only<br />
need to read this section if you are carrying out the installation yourself.<br />
To connect the receiver<br />
Sat-IF connection<br />
14<br />
You will find sample configurations in the section "Connection examples".<br />
First carry out all installation work before connecting the receiver to the mains<br />
power supply.<br />
Refer to the information provided in the section on "Safety".<br />
Connect the Sat-IF input of the receiver to the satellite receiving system (satellite<br />
dish).<br />
Use a coaxial cable with a standard F connector for this purpose.<br />
If you need to fit the F-connector onto the cable,<br />
• strip the cable insulation as shown in the diagram (you will need to fold back<br />
the braid) and<br />
• slide the F-connector onto the cable, then turn it clockwise until it locks.<br />
When fitting the connector make sure that no wires of the shield braid make<br />
contact with the inner conductor. This could otherwise cause a short-circuit.<br />
The quality of the reception signal depends on a good connection!<br />
Analogue and digital TV<br />
To ensure you can receive digital and analogue channels, connect the IF OUTPUT<br />
socket with the IF INPUT ANALOG socket at the rear of the receiver. Use the coax<br />
jumper provided as an accessory for this purpose.<br />
Presetting of the receiving system<br />
Make sure that your satellite antenna system transmits both the low band as well<br />
as the high band for analogue and digital reception. For digital reception, your<br />
single satellite antenna (dish) must be equipped with at least one universal LNB.<br />
The control signals for conventional receiving systems (satellite dishes) are preset,<br />
i.e. 14/18 V for polarization changeover and 22 kHz switching signal for LOW/HIGH<br />
band changeover on multifeed reception systems.<br />
The presetting will need to be changed in the installation menu, menu point<br />
"DiSEqC" if UFO or tone burst switching matrices are used in the receiving system.<br />
Refer to the section "Installation menu, DiSEqC menu“ for this purpose.<br />
It is important that you observe the application information provided for the matrix<br />
used.
Change language