9986252-DVB Satellite Receiver UFD 545 - Kathrein
9986252-DVB Satellite Receiver UFD 545 - Kathrein
9986252-DVB Satellite Receiver UFD 545 - Kathrein
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Installation Menu<br />
DiSEqC (UFO) setup<br />
22 kHz signal<br />
Tone-burst and DiSEqC-signal<br />
You should only make changes in this<br />
menu when the receiver is to be<br />
connected to another receiving system<br />
with different features or if changes have<br />
been made to the receiving system.<br />
Therefore, take particular note of the information relating to your Sat-IF system.<br />
Before making any changes, you should make a note of these settings on the form<br />
provided at the end of this User's Guide.<br />
Press the menu buttons M, ou and O to open the DiSEqC menu.<br />
In this menu point you can determine whether the 22 kHz signal is to be used to<br />
switch over between the low and high frequency range of a satellite or between<br />
2 satellite positions.<br />
A DiSEqC control signal is necessary if more than four control criteria are required<br />
in a receiving system.<br />
Which of the setting options, i.e. tone burst or DiSEqC is required depends on the<br />
components of the receiving system.<br />
Therefore refer to the description of the components (switchover matrices) of the<br />
receiving system.<br />
41