full PDF - Fellers

Heat Tools
Great for “setting” the vinyl after vehicle
wrapping. Exclusive DuraTherm heating
element ensures long life and even heat.
Temperature selection in 10° F
increments from 120-1150° F with LCD
display. 3 fan speeds: 3.6, 10.6 and 17.6
CFM. Kit includes attachments to
disperse heat and carrying case.
ea.
STEINELGUN
86
HL 2010 E Heat Set Gun
UltraHEAT II SV 803 Variable
Temperature Heat Gun
Variable temperature heat gun featuring 2 airflow
settings (low and high) and a selectable cool air
stage of 140° F. Soft grip handle for comfortable
operation. Temperature adjustable from a low of
140° F to a high of 1050° F. Kit includes heat gun,
72mm spreader nozzle, 39mm reflector nozzle and
heavy duty carrying case.
ea.
STEINELKIT
IR Temperature Gun
The Mastercool IR Temperature gun offers laser targeting
accuracy, enhanced back-lit LCD Display and an expanded
temperature range of -4ºF to 932ºF, -20ºC to 500ºC. The compact
design is simple to use and easy to store. Carrying case and 9V
battery included.
IRGUN
ea.
YelloShuttle
The convenient YelloShuttle has an opening to insert your
Steinel heat gun, allowing you to have the IR
gun and heat gun in one hand, and air release
tool or squeegee in the other hand.
NOTE - Compatible with all Steinel heat gun
models except HL 1610 S, HL 1810 S, and HL
TS4000T Trigger Start Torch
• Instant On-Off trigger increases fuel savings and
convenience
• Lock button keeps torch lit for finger-free use
• Pressure regulated to burn upside down
BZ8250 HT
Trigger Start Hose Torch
• 5 ft hose for increased mobility
• Slender design for maximum accessibility
• Comfort Grip for extended use
• Instant on/off trigger start for ease of ignition
• Continuous run lock for ease of operation
• Ultra swirl flame maximum heat output
• Includes Fat Boy fuel holster
A must have tool for
vehicle wraps!
Disposable Propane Cylinders
• Disposable propane cylinders for use with torches.
• Propane offers consistent reliable heat for vehicle wrap
installations
• Some of our customers prefer propane to MAPP gas
which can get too hot and possibly burn vinyl.
16.04 oz. qty 4 or more
PROPANE16
We cannot ship. available for
pick-up and courier orders only
2010 E. “Whether you use a torch or a heat gun on your wraps,
heat is an important part of any wrap. Heat can be used
to make pressure sensitive vinyl conformable around
curves, rivets, and other irregular surfaces. Post heat
YSHUTTLE
HOSETORCH
16.04 oz.
is also a critical step when doing vehicle wraps to help
“set” the vinyl. Direct heat should especially be applied to
areas where the vinyl has been stretched. Slowly move
the heat source across these areas until
the Mastercool Infrared Temperature Gun
reads no more than 200 degrees
Fahrenheit (most manufacturers
recommend not heating vinyl beyond
200 degrees), then move the heat
source approximately one inch every
two to three seconds. This technique
relaxes the stress on the vinyl caused by
stretching, which will help prevent lifting
and tenting.”
– Frank
WarnInG: Do not use heat
sources near gas tanks or
flammable substance
TRIGGER
ea.