PowerMax™-USB/RS - Coherent

PowerMax-USB/RS User Manual
Current Wavelength Command
Sets the current wavelength, which is committed to persistent
storage when it is changed. If the requested wavelength is greater
than the upper wavelength limit, the requested wavelength is set to
the upper wavelength limit. Likewise, if the requested wavelength is
less than the lower wavelength limit, the requested wavelength is set
to the lower wavelength limit.
Command: wv
Reply:
Current Power Reading Query
Queries the current power reading.
Query: pw?
Reply:
Current Beam Position Query
Queries the current beam position. If the sensor is an optical sensor,
the returned position X and Y values are 0.
Query: pos
Reply (thermopile quad sensor): ,
Reply (thermopile mono or optical sensor): 0,0
Note that X and Y positions are zero if the sensor is a thermopile
mono or if the power is less than 10% of the minimum range (see
“Minimum Range Query” on page 67).
Current Thermistor Counts Query
Queries the current thermistor ADC value.
Query: tmp
Reply:
Start Data Streaming Command
Enables LaserPAD/SSIM mode interface data streaming. Streaming
data records are transmitted at 10 Hz. Streaming data records
continue to be transmitted until the Stop Data Streaming command
(see below) is issued.
Command: dst
Reply: none
68