Programming Guide 11/2002 Edition - Flint Machine Tools, Inc.

08.99
12.97 General
1 1.5 Cycle support in program editor (SW 5.1 and higher)
Operator commands in the help display
Page
up
Page
down
next
entry
Go to
Paging backward in the documentation.
Paging forward in the documentation.
Enables the jump to another piece of text
included in the help display.
Enables the jump to a selected piece of
text.
Zoom + Zoom the text in the help window.
Zoom - Reduce the text in help window.
Exit
help
Return to the cycle screen form.
Contour input support
Free contour programming
Generate
contour Starts free contour
programming for entering
assembled contour sections
(refer to References: /OG/,
Chapter 6).
Blueprint programming
Contour
1 line
Contour
2 lines
Contur
3 lines These soft keys
support blueprints that are
possible with SW 5 or higher.
It consists of one or several straight lines with
contour transition elements in-between (radii,
chamfers). Each contour element may be
preassigned by means of end points or point and
angle and supplemented by a free DIN code.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition 1-43
1