Wire Rope Hoists _ Operating and Maintenance ... - STAHL-POLSKA
Wire Rope Hoists _ Operating and Maintenance ... - STAHL-POLSKA
Wire Rope Hoists _ Operating and Maintenance ... - STAHL-POLSKA
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6 Inspection <strong>and</strong> maintenance<br />
44<br />
1/1<br />
2/2-1<br />
2/1<br />
4/2-1<br />
a [mm]<br />
50 Hz 60 Hz<br />
130 150<br />
70 80<br />
4/1 40 50<br />
6.8.8 Setting hoist limit switch<br />
The cover of the limit switch must be removed to set the contacts. This exposes live<br />
contact connections. There is thus a danger of contact with live parts!<br />
The limit switch can be adjusted at the setscrews (S1)-(S3) or (S1)-(S4):<br />
Turning to the left: switching point is moved "downwards",<br />
Turning to the right: switching point is moved "upwards".<br />
Adjusting en bloc<br />
All the cam discs can be moved together with the aid of the black setscrew (S0). The<br />
settings of the individual contacts relative to one another remain unchanged.<br />
Set the limit switch using a socket spanner (04 430 50 99 0) <strong>and</strong> without using excessive<br />
force. Do not use a power screwdriver or similar.<br />
Adjust the switching points in the following sequence:<br />
Emergency limit switch:<br />
1. A↑ (S3/S4))<br />
2. S↑ (S1)<br />
2. A↓ (S2)<br />
Switching point A↑ (S3/S4)<br />
"Emergency limit switch top hook position"<br />
Lift bottom hook block 2/1 to a+10 mm or to a+5 mm for 4/1 (sketch, table).<br />
If necessary turn setscrew (S3/S4 <strong>and</strong> S1) to the right beforeh<strong>and</strong>.<br />
Turn setscrew (S3 or S4) to the left until contact S3 or S4 switches audibly.<br />
Check cut-off point in main <strong>and</strong> creep hoist<br />
Switching point S↑ (S1)<br />
"Safety limit switch above top hook position"<br />
Lift bottom hook block until emergency hoist limit switch is reached, if necessary<br />
turn setscrew (S1) to the right beforeh<strong>and</strong>.<br />
Turn setscrew (S1) to the left until contact S1 switches audibly.<br />
Turn setscrew (S1) back to the right by approx. ½ turn.<br />
Switching point A↓ (S2)<br />
"Emergency limit switch bottom hook position"<br />
(Minimum clearance between rope guide (S) <strong>and</strong> clamping claws (K) for rope<br />
anchorage = 20 mm, see sketch)<br />
Set bottom hook position so that the bottom hook block does not touch the ground<br />
(would cause slack rope).<br />
Lower bottom hook block to desired hook position, if necessary turn setscrew (S2)<br />
to the left beforeh<strong>and</strong>.<br />
Turn setscrew (S2) to the right until contact S2 switches audibly.<br />
Check cut-off point in main <strong>and</strong> creep hoist.<br />
*1 Effective hook path<br />
10.08<br />
BASH_02_1.FM