Important Placement Instructions Enclosed See Lifting - Haas ...

Servo Bar 300 Quick Start Guide
1. Install a spindle liner for the bar size used and adjust the transfer table to proper height. The bar
must slide from transfer table into the liner without interference.
2. Load bar stock on to the storage tray. Note: The bar length must be a minimum 2.25 x the gap
between the Bar Feeder and the liner, or at least 10" (254mm) long.
3. Press Curnt Comds, and page down to the Servo Bar page. Enter the part length + cutoff, initial
push length and the minimum clamping length.
4. Enter G105 Q4 - Jog To Reference Position, in MDI mode and press Cycle Start. The bar will be
loaded and pushed through the liner to within 4" (102mm) of the collet face. Press Reset and jog
the end of bar to the reference position. Close collet.
5. Enter G105 Q2 - Set Reference Position, in MDI mode. Bar Feeder is ready for operation. Write
a machining program that has the G105 command at the end of the program.
Original Instructions
Haas Technical Publications
Installation, Application and Operator’s Manual
96-0013, Rev. BB Aug 2012
PAgE 31 OF 66