Important Placement Instructions Enclosed See Lifting - Haas ...

3. Push the the interface plate in, then slide it
down so the coolant collector tabs lock it in
place.
If the interface plate does not slide into
place, tap it gently into place with a dead
blow hammer.
4. With the small hole on the flange at the top
(A), put the bar tube into the interface plate.
The mounting tabs on the tube fit into the
slots on the plate. For clarity, inset view (B)
illustrates this from the other side of the
plate.
5. Turn the bar tube clockwise until the small
hole in the bar tube flange (A) lines up with
the small hole in the interface plate (B).
To remove the interface plate, remove any bar between the lathe and the Bar Feeder, turn the
bar tube counter-clockwise to remove the tube, then pull the interface plate up and out of the
coolant collector.
Original Instructions
Haas Technical Publications
Installation, Application and Operator’s Manual
96-0013, Rev. BB Aug 2012
A
B
B
A
PAgE 9 OF 66