Important Placement Instructions Enclosed See Lifting - Haas ...
Important Placement Instructions Enclosed See Lifting - Haas ...
Important Placement Instructions Enclosed See Lifting - Haas ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Original <strong>Instructions</strong><br />
<strong>Haas</strong> Technical Publications<br />
Installation, Application and Operator’s Manual<br />
Bar Feeder Height Adjustment<br />
Note: The Bar Feeder is shipped in only one of two height configurations to match the<br />
models indicated. ST-10, ST-20 Series, ST-30, DS-30 Series.<br />
<strong>Important</strong><br />
Use one of the three following methods to adjust Bar Feeder height. Be aware that the<br />
Bar Feeder weighs 1300 lb (590 kg) and all necessary precautions should be taken into<br />
consideration to safely change the height of the Bar Feeder. For example, lifting straps should be<br />
able to adequately carry the weight of the Bar Feeder. Forks of the forklift should be long enough<br />
to reach under the rear tray of the Bar Feeder.<br />
IMPORTANT<br />
Sheetmetal is cut-out<br />
around SHCS<br />
DO NOT REMOVE THIS BOLT<br />
OR THE BOLT ON THE<br />
OPPOSITE CORNER IN BACK<br />
Support the weight of the Bar Feeder with the forklift or cables. Remove all the SHCS at each<br />
corner of the base, except for the lower outside bolts on the front legs.<br />
Raise the Bar Feeder to the desired height, and replace the bolts (see the following<br />
illustrations). Note that the studs on the rear of the Bar Feeder are to fasten the base and rear<br />
support bracket together. These are not to be removed.<br />
96-0013, Rev. BB Aug 2012<br />
PAgE 51 OF 66
Change language