Important Placement Instructions Enclosed See Lifting - Haas ...

Push Rod Adjustment (3/8" Push Rod shown)
1. Adjust the transfer table to between 10° and
15° of elevation. Place a piece of 3/8" stock
approximately 1" (25mm) from the transfer
table stop. Allow the rod to roll down the
charging table. Raise the transfer table until
the rod does not overrun the transfer table
stops.
2. Lower the push rod arms and install the
push rod connector. The push rod connector
should be adjusted flush with the bottom of
the pusher nose by raising or lowering the
set screw in the push rod carriage.
3. Raise or lower the push control bushing
assembly to align the push rod parallel with
the charging table.
Original Instructions
Haas Technical Publications
Installation, Application and Operator’s Manual
96-0013, Rev. BB Aug 2012
Transfer Table Stop
for 1/4 to 3/8 Bar
Set Screw
Push Control
Bushing
Assembly
PAgE 37 OF 66