xTalk Management Console for Windows User's Guide

Chapter 6 Running a Test or Task
Running a Test or Task
Running a Test or Task 6
To run a test or task:
1 Select the device on which you want to run the test or task from the
Device Selection Panel.
2 Select the script you want to run from the Script Selection Panel, or
click a toolbar button (if you click a button, skip step 3).
3 Start the test or task by doing one of the following:
• Click the Run button on the toolbar.
• Double-click the test or task.
Note: If the test or task will take a long time to complete, a dialog box
opens telling you how long it will take. You can click Yes to
continue or No to stop.
Note: If a TapeAlert exists, xTalk Management Console displays the
TapeAlert dialog box (see chapter 9, Viewing TapeAlerts). The
test or task may or may not continue running, depending on
the severity of the TapeAlert.
4 Follow the instructions displayed in the Results Panel or in any
dialog box that may open regarding the test or task.
xTalk runs the test or task, displaying the results in the Results Panel.
5 For information on how to save these results or send them to a
recipient, see the following sections:
• Chapter 7, Log Files
• Saving the Contents of the Results Panel on page 14
• Sending the Contents of the Results Panel on page 15
xTalk Management Console for Windows User’s Guide 34