SIREC DS Display Recorder 7ND4120-xxx - Siemens

The recorder sends messages for distribution by a remote e-mail server. The e-mail
server is located by its IP address as set-up in the communications set-up options. When
the recorder sends an e-mail message, it locates the e-mail server you have configured
and uses SMTP (Simple Message Transfer Protocol) to send the message to the e-mail
server. SMTP allows the recorder to send messages to an e-mail server without having
its own e-mail address; because of this the e-mail server will not be able to send any reply
back to the recorder.
Factory
Function: Unit Calibration and Alarm card setup
Type: Menu selection
Description: Calibration of analogue input card and configuration of Relay/Digital.
Default: N/A
From the Factory option on the General menu use the directional key to select, as
shown in ”Setup’ on page 31, press the enter button to generate the sub menus. Use
this menu route to calibrate the analogue card for input or output of analogue signal. The
Drives item is for the 1.4 Mbyte floppy drive disk only. Reset Setup will reset to the factory
settings, highlight and press enter button. Follow on-screen instructions during this procedure.
Calibrate Input
Recorder
Ethernet
LAN
Local Area Network
Mail Server
The type of Analogue card fitted in this recorder has the following menu screens,
within the Calibrate Input option. Up to 6 analogue channels are available. Individual
input channels can be switched on or off by selecting Inputs and entering a tick or a cross
in the Calibrate option.
Select Analogue In ‘All’ to identify which channels require calibration using a ✓.
‘F’ indicates the input is calibrated to the factory setting. If any power loss should
occur the unit will retain the calibration settings at the time of power loss.
Input channels can be calibrated individually, indicated by the disappearance of the
‘F’. The other inputs are not effected and will calibrate to the factory settings.
40 43-TV-25-20 GLO Issue 5 06/04 UK
A5E00117351-05