Owner's Manual - Touchboards.com
Owner's Manual - Touchboards.com
Owner's Manual - Touchboards.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
EIP-5000/5000L<br />
Temperature<br />
warning<br />
indicator<br />
Lamp<br />
indicators<br />
1, 2<br />
Power<br />
indicator<br />
Info<br />
Maintenance indicator<br />
Normal Abnormal<br />
Off<br />
Red on<br />
(Standby)<br />
Green on Red on<br />
Green blinks<br />
when the lamp<br />
is warming up.<br />
Red on<br />
(Standby)<br />
Green on/<br />
Red on<br />
Green<br />
blinks<br />
Problem Cause Possible solution<br />
The internal<br />
temperature is<br />
abnormally high.<br />
The lamp does<br />
not illuminate.<br />
Time to change<br />
the lamp.<br />
Thelampdoes<br />
not illuminate.<br />
The power<br />
indicator blinks in<br />
green when the<br />
projector is on.<br />
• Blocked air intake<br />
• Cooling fan breakdown<br />
• Internal circuit failure<br />
• Clogged air intake<br />
• Clogged intake vent<br />
cover<br />
• The lamp is shut<br />
down abnormally.<br />
• Remaining lamp life<br />
be<strong>com</strong>es 5% or less.<br />
• Burnt-out lamp<br />
• Lamp circuit failure<br />
• The intake vent<br />
cover is open.<br />
1 – 11<br />
• Relocate the projector to an area<br />
with proper ventilation.<br />
• Take the projector to your nearest<br />
EIKI Authorized Dealer or Service<br />
Center for repair.<br />
• Clean the air vents and the intake<br />
vent cover.<br />
• Disconnect the power cord from<br />
the AC outlet, and then connect it<br />
again.<br />
• Carefully replace the lamp.<br />
• Take the projector to your nearest<br />
EIKI Authorized Dealer or Service<br />
Center for repair.<br />
• Please exercise care when<br />
replacing the lamp.<br />
• Securely install the cover.<br />
• If the power indicator blinks even<br />
when the intake vent cover is<br />
securely installed, contact your<br />
nearest EIKI Authorized Dealer or<br />
Service Center for advice.<br />
• If the temperature warning indicator blinks and the projector enters the standby mode, the temperature<br />
warning indicator starts to illuminate. Check whether any of the ventilation holes are blocked<br />
and then try turning the power back on. Wait until the projector has cooled down <strong>com</strong>pletely before<br />
plugging in the power cord and turning the power back on. (At least 10 minutes.)<br />
• If the power is turned off for a brief moment due to power outage or some other cause while using the<br />
projector, and the power supply recovers immediately after that, the lamp indicator will illuminate in red<br />
and the lamp may not be lit. In this case, unplug the power cord from the AC outlet, replace the power<br />
cord in the AC outlet and then turn the power on again.<br />
• The cooling fan keeps the internal temperature of the projector constant and this function is controlled<br />
automatically. The sound of the cooling fan may change during operation because the fan speed may<br />
change and this is not a malfunction.