Owner's Manual - Touchboards.com

EIP-5000/5000L
[3] Special 232c command for factory
How to write MAC address (Write) Send the following 232c commands in sequence
1. _ L M A 0 0 *1 *2 +"enter" key *1 the first byte
wait "OK" *2 the second byte
2. _ L M A 1 0 *3 *4 + "enter" key *3 the third byte
wait "OK" *4 the fourth byte
3. _ L M A 2 0 *5 *6 + "enter" key *5 the fifth byte
wait "OK" *6 the sixth byte
4. _ L M A 3 0 *7 *8 + "enter" key *7 the seventh byte
wait "OK" *8 the eighth byte
5. _ L M A 4 0 *9 *10 + "enter" key *9 the ninth byte
wait "OK" *10 the 10th byte
6. _ L M A 5 0 *11 *12 + "enter" key *11 the 11th byte
*12 the 12th byte
(Read) Send the following 232c commands
_ L M A 1 + "enter" key
MAC address will be appear on screen
How to write serial number (Write) Send the following 232c commands in sequence.
1. S N _ 1 1 2 3 4 + “enter” key
wait “OK”
2. S N _ 2 5 6 7 8 + “enter” key
wait “OK”
3. *1 *2 *3 *4 *5 *6 *7 *8 *9 *10 *11 *12 + “enter” key
4. *1 *2 *3 *4 *5 *6 *7 *8 *9 *10 *11 *12 + “enter” key
wait “OK”
(Read) Send the following 232c commands
S N R D 1 + “enter” key
serial number will be appear on screen
*1~*12/serial number
same data as step3
NOTE: When number of characters of the serial number is shorter than twelve characters,
please use space character ““.
for example
serial number is “1311163”
1 3 1 1 1 6 3 + “enter” key
serial number is “412311112”
4 1 2 3 1 1 1 1 2 + “enter” key
How to check projector status (Read) Send the following 232c commands
T F C K 1 + “enter” key
serial number will be appear on screen
3 – 4