19.07.2013 Views

CCNP TSHOOT 6.0 - Cisco Learning Home

CCNP TSHOOT 6.0 - Cisco Learning Home

CCNP TSHOOT 6.0 - Cisco Learning Home

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>CCNP</strong>v6 <strong>TSHOOT</strong><br />

b. Issue the show interfaces fa0/0 command and note the transmit and receive loads (txload and<br />

rxload).<br />

________________________________________________________________________________<br />

________________________________________________________________________________<br />

R3#show interfaces fa0/0<br />

FastEthernet0/0 is up, line protocol is up<br />

Hardware is Gt96k FE, address is 001b.530d.6028 (bia 001b.530d.6028)<br />

Internet address is 10.1.80.1/24<br />

MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,<br />

reliability 255/255, txload 1/255, rxload 1/255<br />

c. Issue the show interfaces fa0/0 stats command. Record the switching path and the packets<br />

in and out for processor and route cache.<br />

________________________________________________________________________________<br />

________________________________________________________________________________<br />

R3#show interfaces fa0/0 stats<br />

FastEthernet0/0<br />

Switching path Pkts In Chars In Pkts Out Chars Out<br />

Processor 50 16309 176 18457<br />

Route cache 1 159 0 0<br />

Total 51 16468 176 18457<br />

Total 116557 66924378 115034 6384079<br />

d. Issue the show interfaces fa0/0 summary command for Fa0/0 and note the transmit (tx) and<br />

receive (rx) rates in bits per second and packets per second. With no load, there might be very little<br />

activity.<br />

________________________________________________________________________________<br />

________________________________________________________________________________<br />

R3#show interfaces fa0/0 summary<br />

*: interface is up<br />

IHQ: pkts in input hold queue IQD: pkts dropped from input queue<br />

OHQ: pkts in output hold queue OQD: pkts dropped from output queue<br />

RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)<br />

TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)<br />

TRTL: throttle count<br />

Interface IHQ IQD OHQ OQD RXBS RXPS TXBS TXPS TRTL<br />

------------------------------------------------------------------------<br />

* FastEthernet0/0 0 0 0 0 0 1 0 0 0<br />

e. Issue the show processes cpu sorted command on R3 and note the CPU utilization for five<br />

seconds, one minute, and five minutes. Also note that the processes running are sorted by highest<br />

CPU utilization.<br />

________________________________________________________________________________<br />

________________________________________________________________________________<br />

All contents are Copyright © 1992–2010 <strong>Cisco</strong> Systems, Inc. All rights reserved. This document is <strong>Cisco</strong> Public Information. Page 5 of 32

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!