Operating Instructions - Panasonic Business

12
Connections
Video equipment connection
SLOT: Terminal board (optional
accessories) insert slot
(see page 6)
Note:
The right side slot is for factory use only.
The terminal board with 1-slot width
does not function when installed in the
right side slot.
LAN: Connect to
a network to
control the unit.
(see page 65)
VIDEO and COMPONENT / RGB IN connection
RCA-BNC
Adapter plug
RCA-BNC
Adapter plug
3D IR TRANSMITTER:
Connect the 3D IR
TRANSMITTER (optional
accessory).
AV IN (VIDEO): Composite Video Input Terminal
(see below)
COMPONENT/RGB IN: Component/RGB Video Input
Terminal (see below)
AV IN (HDMI): HDMI Input Terminal (see page 13)
Connect to video equipment such as VCR or DVD player.
Note:
Additional equipment, cables and adapter plugs shown are not supplied with this set.
Y
P B
Y , P B , P R ,
OUT
PR
L
R
L
R
AUDIO
OUT
AUDIO
OUT
VIDEO
OUT
SERIAL:
Control the Plasma Display
by connecting to PC.
(see page 15)
Terminals are on the bottom side of the Plasma Display.
DVI-D IN: DVI-D Input Terminal
(see page 13)
PC IN: PC Input Terminal
Connect to video terminal of PC
or equipment with Y, PB(CB) and
PR(CR) output. (see page 14)
VCR
Notes:
• Change the “COMPONENT/RGB-IN select” setting in the “SETUP”
menu to “COMPONENT” (when COMPONENT signal connection)
or “RGB” (when RGB signal connection). (see page 40)
• Signals input to COMPONENT/RGB IN terminals correspond to
SYNC ON G or SYNC ON Y.
DVD Player
Computer RGB Camcorder