Aprilia SR 50 servicemanual - Scootergrisen

More documents

Recommendations

Info

SR 50 5.5. BRAKING SYSTEM 5.5.1. CHANGING THE BRAKE PADS • Position the vehicle on the center stand. • Remove the brake caliper from the disc, but leave the line connected. For the front brake caliper only: • Remove the brake caliper cover. WARNING Be careful not to damage the rim paint during removal and reassembly of the caliper on the disc. While changing pads, protect the rim with tape. CYCLE PARTS 5 - 25
CYCLE PARTS • Remove the snap ring (1). • Remove the pin (2). • Remove the spring (3). • Remove the pads (4) sliding them out one at a time. 5 - 26 WARNING Do not operate the brake lever when the pads are not in place or the caliper piston might come off its housing, thus causing brake fluid leakage. Always change both pads and ensure they are correctly in place inside the caliper. • Fit two new brake pads (4). • Correctly seat the spring (3). • Fit the pin (2). • Fit the snap ring (1). For the front brake caliper only: • Refit the brake caliper cover. • Check the brake fluid level, see (BRAKING SYSTEM). SR 50
Page 1 and 2:
www.serviceaprilia.com 8140817 USA
Page 3 and 4:
INTRODUCTION 0 - 2 SR 50 TABLE OF C
Page 5 and 6:
INTRODUCTION 0.1.2. REFERENCE MANUA
Page 7 and 8:
INTRODUCTION TEST = diagnostic chec
Page 9 and 10:
GENERAL INFORMATION 1 - 2 SR 50 TAB
Page 11 and 12:
GENERAL INFORMATION 1.1.2. SAFETY W
Page 13 and 14:
GENERAL INFORMATION HYDROGEN GAS AN
Page 15 and 16:
GENERAL INFORMATION 1.3. DANGEROUS
Page 17 and 18:
GENERAL INFORMATION COOLANT 1 - 10
Page 19 and 20:
GENERAL INFORMATION 1.5. VEHICLE ID
Page 21 and 22:
3 4 5 6 GENERAL INFORMATION 1 - 14
Page 23 and 24:
11 12 13 14 GENERAL INFORMATION 1 -
Page 25 and 26:
SR 50 PERIODIC MAINTENANCE PERIODIC
Page 27 and 28:
SR 50 2.1. SPECIFICATIONS 2.1.1. TE
Page 29 and 30:
SR 50 2.1.2. SCHEDULED MAINTENANCE
Page 31 and 32:
SR 50 2.1.4. TIGHTENING TORQUES PER
Page 33 and 34:
SR 50 Description Q.ty Type of fast
Page 35 and 36:
SR 50 2.1.5. MULTIFUNCTION DIGITAL
Page 37 and 38:
SR 50 • CHRONOMETER sub-menu: thi
Page 39 and 40:
SR 50 DELETE ERRORS: Select this fu
Page 41 and 42:
SR 50 RESTORE CODE: If the user for
Page 43 and 44:
SR 50 2.2. SCHEDULED MAINTENANCE 2.
Page 45 and 46:
SR 50 CHECKING BRAKE PAD WEAR CAUTI
Page 47 and 48:
SR 50 2.2.2. CLEANING THE AIR FILTE
Page 49 and 50:
SR 50 • Start the vehicle and let
Page 51 and 52:
SR 50 CHANGE • Position the vehic
Page 53 and 54:
SR 50 • Unscrew and remove the fi
Page 55 and 56:
SR 50 2.2.7. MIXER OIL IE50 TOPPING
Page 57 and 58:
FUEL SYSTEM 3 - 2 TABLE OF CONTENTS
Page 59 and 60:
FUEL SYSTEM 3.1.2. FUEL SUPPLY SYST
Page 61 and 62:
FUEL SYSTEM • Loosen and remove t
Page 63 and 64:
FUEL SYSTEM • Loosen and remove t
Page 65 and 66:
FUEL SYSTEM 3.2. AIR FILTER 3.2.1.
Page 67 and 68:
FUEL SYSTEM 3.2.2. REMOVING THE AIR
Page 69 and 70:
FUEL SYSTEM 3.3.2. REMOVING THE THR
Page 71 and 72:
FUEL SYSTEM 3.4. CARBURETOR 3.4.1.
Page 73 and 74:
FUEL SYSTEM • Disconnect the auto
Page 75 and 76:
SR 50 ENGINE ENGINE 4 4- 1
Page 77 and 78:
SR 50 4.1. ENGINE IE 361 4.1.1. REM
Page 79 and 80:
SR 50 • Remove the rubber plug.
Page 81 and 82: SR 50 • Working on the right side
Page 83 and 84: SR 50 • Connect the connector to
Page 85 and 86: SR 50 • Connect the generator con
Page 87 and 88: SR 50 4.2. ENGINE IE 50 4.2.1. REMO
Page 89 and 90: SR 50 • Disconnect the fuel injec
Page 91 and 92: SR 50 4.2.2. INSTALLING THE ENGINE
Page 93 and 94: SR 50 • Fit the spark plug cap.
Page 95 and 96: SR 50 4.3. ENGINE C 364 4.3.1. REMO
Page 97 and 98: SR 50 • Loosen and remove the two
Page 99 and 100: SR 50 • Working on the opposite s
Page 101 and 102: SR 50 • Connect the connector.
Page 103 and 104: SR 50 • Connect the temperature s
Page 105 and 106: SR 50 SAS The Secondary Air System
Page 107 and 108: SR 50 ENGINE 4- 33
Page 109 and 110: CYCLE PARTS 5 - 2 SR 50 TABLE OF CO
Page 111 and 112: CYCLE PARTS 5.1.2. REMOVING THE PAS
Page 113 and 114: CYCLE PARTS • Disconnect the tail
Page 115 and 116: CYCLE PARTS 5.1.5. REMOVING THE FRO
Page 117 and 118: CYCLE PARTS 5.1.7. REMOVING THE REA
Page 119 and 120: CYCLE PARTS 5.1.9. REMOVING THE INN
Page 121 and 122: CYCLE PARTS 5.1.10. REMOVING THE HE
Page 123 and 124: CYCLE PARTS 5.1.11. REMOVING THE FR
Page 125 and 126: CYCLE PARTS • Loosen and remove t
Page 127 and 128: CYCLE PARTS 5.2.2. REMOVING THE EXH
Page 129 and 130: CYCLE PARTS 5.3.2. REMOVING THE FRO
Page 131: CYCLE PARTS 5.4.2. REMOVING THE REA
Page 135 and 136: CYCLE PARTS 5.7. FRONT FORK 5.7.1.
Page 137 and 138: CYCLE PARTS 5.7.3. DISASSEMBLING TH
Page 139 and 140: SR 50 COOLING SYSTEM COOLING SYSTEM
Page 141 and 142: SR 50 6.1. COOLING SYSTEM 6.1.1. DI
Page 143 and 144: SR 50 ELECTRICAL SYSTEM ELECTRICAL
Page 145 and 146: SR 50 7.1. CHECKING THE ELECTRICAL
Page 147 and 148: SR 50 7 Fuel sensor: resistance acr
Page 149 and 150: SR 50 7.1.2. CHECKING THE COMPONENT
Page 151 and 152: SR 50 7 Fuel sensor: resistance acr
Page 153 and 154: SR 50 7.1.3. CHECKING THE COMPONENT
Page 155 and 156: SR 50 7 Headlight: low beam 12 V -
Page 157 and 158: SR 50 Key: 1. Multiple connectors 2
show all

Aprilia SR 50 servicemanual - Scootergrisen

Create successful ePaper yourself

Delete template?

Save as template?