Aprilia SR 50 servicemanual - Scootergrisen

More documents

Recommendations

Info

ELECTRICAL SYSTEM 11 Throttle body FUEL INJECTOR winding resistance: 1.7 ohms THROTTLE POSITION SENSOR (TPS): - resistance across terminals 1 and 4: 1.1 kOhms Throttle grip CLOSED - resistance across terminals 1 and 2: 1.1 kOhms - resistance across terminals 1 and 3: 1.9 kOhms Throttle grip OPEN - resistance across terminals 1 and 2: 1.9 kOhms - resistance across terminals 1 and 3: 1.1 kOhms tolerance on measured values: ± 10% 12 Air injector: winding resistance: 1.3 ohms 13 Coolant temperature sensor NTC sensor resistance: 2.7 kOhms at 20 °C 7 - 6 SR 50
SR 50 7.1.2. CHECKING THE COMPONENTS IE50 1 Generator: three-phase generator winding resistance: 1 ohm output voltage 50AC (to be measured with generator disconnected from wiring system and engine at 3000 rpm) 2 Rpm sensor: inductive sensor winding resistance: 110 ohms ELECTRICAL SYSTEM 7 - 7
Page 1 and 2:
www.serviceaprilia.com 8140817 USA
Page 3 and 4:
INTRODUCTION 0 - 2 SR 50 TABLE OF C
Page 5 and 6:
INTRODUCTION 0.1.2. REFERENCE MANUA
Page 7 and 8:
INTRODUCTION TEST = diagnostic chec
Page 9 and 10:
GENERAL INFORMATION 1 - 2 SR 50 TAB
Page 11 and 12:
GENERAL INFORMATION 1.1.2. SAFETY W
Page 13 and 14:
GENERAL INFORMATION HYDROGEN GAS AN
Page 15 and 16:
GENERAL INFORMATION 1.3. DANGEROUS
Page 17 and 18:
GENERAL INFORMATION COOLANT 1 - 10
Page 19 and 20:
GENERAL INFORMATION 1.5. VEHICLE ID
Page 21 and 22:
3 4 5 6 GENERAL INFORMATION 1 - 14
Page 23 and 24:
11 12 13 14 GENERAL INFORMATION 1 -
Page 25 and 26:
SR 50 PERIODIC MAINTENANCE PERIODIC
Page 27 and 28:
SR 50 2.1. SPECIFICATIONS 2.1.1. TE
Page 29 and 30:
SR 50 2.1.2. SCHEDULED MAINTENANCE
Page 31 and 32:
SR 50 2.1.4. TIGHTENING TORQUES PER
Page 33 and 34:
SR 50 Description Q.ty Type of fast
Page 35 and 36:
SR 50 2.1.5. MULTIFUNCTION DIGITAL
Page 37 and 38:
SR 50 • CHRONOMETER sub-menu: thi
Page 39 and 40:
SR 50 DELETE ERRORS: Select this fu
Page 41 and 42:
SR 50 RESTORE CODE: If the user for
Page 43 and 44:
SR 50 2.2. SCHEDULED MAINTENANCE 2.
Page 45 and 46:
SR 50 CHECKING BRAKE PAD WEAR CAUTI
Page 47 and 48:
SR 50 2.2.2. CLEANING THE AIR FILTE
Page 49 and 50:
SR 50 • Start the vehicle and let
Page 51 and 52:
SR 50 CHANGE • Position the vehic
Page 53 and 54:
SR 50 • Unscrew and remove the fi
Page 55 and 56:
SR 50 2.2.7. MIXER OIL IE50 TOPPING
Page 57 and 58:
FUEL SYSTEM 3 - 2 TABLE OF CONTENTS
Page 59 and 60:
FUEL SYSTEM 3.1.2. FUEL SUPPLY SYST
Page 61 and 62:
FUEL SYSTEM • Loosen and remove t
Page 63 and 64:
FUEL SYSTEM • Loosen and remove t
Page 65 and 66:
FUEL SYSTEM 3.2. AIR FILTER 3.2.1.
Page 67 and 68:
FUEL SYSTEM 3.2.2. REMOVING THE AIR
Page 69 and 70:
FUEL SYSTEM 3.3.2. REMOVING THE THR
Page 71 and 72:
FUEL SYSTEM 3.4. CARBURETOR 3.4.1.
Page 73 and 74:
FUEL SYSTEM • Disconnect the auto
Page 75 and 76:
SR 50 ENGINE ENGINE 4 4- 1
Page 77 and 78:
SR 50 4.1. ENGINE IE 361 4.1.1. REM
Page 79 and 80:
SR 50 • Remove the rubber plug.
Page 81 and 82:
SR 50 • Working on the right side
Page 83 and 84:
SR 50 • Connect the connector to
Page 85 and 86:
SR 50 • Connect the generator con
Page 87 and 88:
SR 50 4.2. ENGINE IE 50 4.2.1. REMO
Page 89 and 90:
SR 50 • Disconnect the fuel injec
Page 91 and 92:
SR 50 4.2.2. INSTALLING THE ENGINE
Page 93 and 94:
SR 50 • Fit the spark plug cap.
Page 95 and 96:
SR 50 4.3. ENGINE C 364 4.3.1. REMO
Page 97 and 98: SR 50 • Loosen and remove the two
Page 99 and 100: SR 50 • Working on the opposite s
Page 101 and 102: SR 50 • Connect the connector.
Page 103 and 104: SR 50 • Connect the temperature s
Page 105 and 106: SR 50 SAS The Secondary Air System
Page 107 and 108: SR 50 ENGINE 4- 33
Page 109 and 110: CYCLE PARTS 5 - 2 SR 50 TABLE OF CO
Page 111 and 112: CYCLE PARTS 5.1.2. REMOVING THE PAS
Page 113 and 114: CYCLE PARTS • Disconnect the tail
Page 115 and 116: CYCLE PARTS 5.1.5. REMOVING THE FRO
Page 117 and 118: CYCLE PARTS 5.1.7. REMOVING THE REA
Page 119 and 120: CYCLE PARTS 5.1.9. REMOVING THE INN
Page 121 and 122: CYCLE PARTS 5.1.10. REMOVING THE HE
Page 123 and 124: CYCLE PARTS 5.1.11. REMOVING THE FR
Page 125 and 126: CYCLE PARTS • Loosen and remove t
Page 127 and 128: CYCLE PARTS 5.2.2. REMOVING THE EXH
Page 129 and 130: CYCLE PARTS 5.3.2. REMOVING THE FRO
Page 131 and 132: CYCLE PARTS 5.4.2. REMOVING THE REA
Page 133 and 134: CYCLE PARTS • Remove the snap rin
Page 135 and 136: CYCLE PARTS 5.7. FRONT FORK 5.7.1.
Page 137 and 138: CYCLE PARTS 5.7.3. DISASSEMBLING TH
Page 139 and 140: SR 50 COOLING SYSTEM COOLING SYSTEM
Page 141 and 142: SR 50 6.1. COOLING SYSTEM 6.1.1. DI
Page 143 and 144: SR 50 ELECTRICAL SYSTEM ELECTRICAL
Page 145 and 146: SR 50 7.1. CHECKING THE ELECTRICAL
Page 147: SR 50 7 Fuel sensor: resistance acr
Page 151 and 152: SR 50 7 Fuel sensor: resistance acr
Page 153 and 154: SR 50 7.1.3. CHECKING THE COMPONENT
Page 155 and 156: SR 50 7 Headlight: low beam 12 V -
Page 157 and 158: SR 50 Key: 1. Multiple connectors 2
show all

Aprilia SR 50 servicemanual - Scootergrisen

Create successful ePaper yourself

Delete template?

Save as template?