Ektron® eWebEditPro Developer's Reference Guide

The Parameters Object
JavaScript Objects
The parameters object is used to set parameters prior to creating an instance of
the editor. This is a property of the eWebEditPro object (for example,
eWebEditPro.parameters).
See Also: “Parameters Object” on page 7
Use the parameters object to change default values for a particular instance of an
editor. To change the default values for all instances of the editor, change the
value in ewebeditprodefaults.js.
The names of most parameters match the names in defaults.js. The different ones
are listed below.
NOTE It is important to retain the case (upper or lower) of the letters when changing a
parameter value.
Parameters Object Properties
default.js parameters.
buttonTagStart .buttonTag.start
buttonTagEnd .buttonTag.end
popup* .popup.* (the first letter after a
popup becomes lowercase)
For a complete list of parameters and their default.js values, see “Customizing
the Popup Button” on page 189.
These properties are the same as those in ewebeditprodefaults.js. In fact,
ewebeditprodefaults initializes the parameters object.
The following parameters are part of the ActiveX control. Go to the listed page
numbers to read about them.
• “Property: hideAboutButton” on page 124
• “Property: Config” on page 122
• “Property: BaseURL” on page 112
• “Property: CharSet” on page 122
• “Property: Title” on page 125
• “Property: bodyStyle” on page 121
For additional Parameters Object properties, methods and events that are not part
of the ActiveX control, see “Parameters Object” on page 7.
Ektron® eWebEditPro Developer’s Reference Guide, Release 5.1, Revision 1 242