CMA Technical Manual - Love Coffee Machines
CMA Technical Manual - Love Coffee Machines
CMA Technical Manual - Love Coffee Machines
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
espresso coffee machine - servings count<br />
MESH FILTER<br />
In order to meet the standards of directives concerning electromagnetic compatibility, it may be necessary to provide the machine with a mesh<br />
filter outside the card.<br />
In this case, its installation requires compliance with a few basic rules:<br />
• the filter (if of a type with a metallic body) must be installed on the metal frame of the unit, with an electrical path of low impedance<br />
towards earth.<br />
• It must be installed as near as possible to the entry point of the of the power cable, with short input and output connections that are set<br />
well apart from each other, to avoid disturbances between the mains, loads and the unit.<br />
If the filter is not installed in compliance these instructions, it may lose all or part of its effectiveness.<br />
PERFORMANCE<br />
Best performance of the card is obtained at an ambient temperature of roughly 25°C.<br />
For higher or lower temperatures, precision and heat dissipation results tend to worsen.<br />
However, the temperature range as defined in the electrical characteristics is adhered to.<br />
To avoid permanent damage to some components, remain within the range 0...70°C.<br />
1.13 WARNINGS<br />
DANGER<br />
The unit contains parts with a high voltage power supply.<br />
Before performing any work, disconnect the unit from the electrical mains.<br />
START-UP<br />
Before providing power to the unit, make all required connections.<br />
PROTECTION<br />
Ensure that all accessible metal parts which may receive live current due to an insulation defect are permanently and securely attached to the<br />
earth terminal of the machine.<br />
Ensure that the earth terminal of the machine is connected to an efficient earth protection<br />
EXTERNAL COMPONENTS<br />
The insertion of components outside the card which are required to ensure suitable reduction of disturbances must not compromise the safety<br />
of the unit. This means that they must be of a suitable type and value.<br />
COMPONENTS<br />
If necessary, we reserve the right to replace the components used with other devices produced by other manufacturers but<br />
with the same electrical and regulatory characteristics.<br />
SOFTWARE<br />
If necessary, we reserve the right to make partial corrections to the described procedures during the software development stage, to allow easier<br />
or more effective use of the machine or a more coherent development of software, without modifying the functional aspects of the machine.<br />
SAFETY<br />
Protection against electrical shock, fire hazard, mechanical risks or hazardous malfunctions in other parts of the machine does not depend on<br />
correct operation of the electronic circuit.<br />
Therefore, where necessary, the machine must be equipped with safety devices which are independent of the electronic circuit (e.g. pressure<br />
overload safety valve).<br />
English - CNS 11<br />
R