CMA Technical Manual - Love Coffee Machines

R
ICD 4 - English
espresso coffee machine - CREDIT-DEBIT system
1. GLORIA Credit-Debit
1.1 Installation
The CREDIT-DEBIT is active in the PLUS1 electronic control units with the code 18090047-18090048 (without display),
PLUS2 with code 18090037-18090038 (with display) and PLUS3 with code 18090051-18090052 (model with cappuccino
/autosteamer) with software program dated 20/05/05 or later.
For installation proceed as follows:
• Turn the machine off;
• activate mobile jumpers JP1 and JP9 as shown in the electrical diagram;
• activate jumpers JP12 and JP14 as shown in the electrical diagram;
• connect the provided cable CC (code 22556003) to the dedicated connector CN4 of the control unit;
• by means of a standard serial cable CS, connect the other end of cable CC to the cash register;
• start the machine again.
NOTE
The cash register management software and the standard serial cable CS (maximum length 15 metres) are not the responsibility
of the manufacturer.
WARNING
In machines with a software program dated 23/06/04 or earlier, the control unit must be replaced.
Programming of doses can be performed without having to disconnect the Credit-Debit device.
If the cash register is enabled, programmed doses are counted. To prevent counting, de-activate jumper JP1 prior to
programming.