netLINK NL 50-MPI

More documents

Recommendations

Info

Device Drawings and Connections 50/65 8 Device Drawings and Connections 8.1 Device Drawing NL 50-MPI Figure 31: Device Drawing NL 50-MPI The pins of the PROFIBUS/MPI interface are connected through 1:1 to the programming device interface. netLINK NL 50-MPI Ethernet | Installation, Operation and Hardware Description DOC080604UM05EN | Revision 5 | English | 2011-09 | Released | Public © Hilscher, 2008-2011
Device Drawings and Connections 51/65 8.2 Ethernet Interface For the Ethernet interface use RJ45 plugs and twisted pair cable of category 5 (CAT5) or higher, which consists of 4 twisted cores and has a maximum transmission rate of 100 MBit/s (CAT5). 8.2.1 Ethernet pinning at the RJ45 Socket Note: The device supports the Auto Crossover function. Due to this fact RX and TX can be switched. The following figure shows the RJ45 standard pinning. PIN 1: TX+ PIN 2: TX- PIN 3: RX+ PIN 4: TERM PIN 5: TERM PIN 6: RX- PIN 7: TERM PIN 8: TERM Figure 32: Ethernet pinning at the RJ45 Socket Pin Signal Meaning 1 TX+ Transmit Data + 2 TX– Transmit Data – 3 RX+ Receive Data + 4 Term 1 Connected to each other and 5 Term 1 terminated to PE through RC circuit* 6 RX– Receive Data – 7 Term 2 Connected to each other and 8 Term 2 terminated to PE through RC circuit* * Bob Smith Termination Table 13: Ethernet pinning at the RJ45 Socket 8.2.2 Ethernet Connection Data Medium 2 x 2 Twisted-Pair copper cable, CAT5 (100 MBit/s) Length of cable max. 100 m Transmission rate 10 MBit/s / 100 MBit/s Table 14: Ethernet Connection Data netLINK NL 50-MPI Ethernet | Installation, Operation and Hardware Description DOC080604UM05EN | Revision 5 | English | 2011-09 | Released | Public © Hilscher, 2008-2011
Page 1 and 2: User Manual netLINK NL 50-MPI Insta
Page 3 and 4: Introduction 3/65 4.3 Ethernet Conn
Page 5 and 6: Introduction 5/65 1 Introduction 1.
Page 7 and 8: Introduction 7/65 1.2 Contents of t
Page 9 and 10: Introduction 9/65 1.3 Legal Notes 1
Page 11 and 12: Introduction 11/65 1.3.5 Export Reg
Page 13 and 14: Safety 13/65 2.4 Labeling of Safety
Page 15 and 16: Safety 15/65 2.6 Safety Instruction
Page 17 and 18: Description and Requirements 17/65
Page 19 and 20: Getting Started 19/65 4 Getting Sta
Page 21 and 22: Installing Software 21/65 5.2 Insta
Page 23 and 24: Configuration 23/65 6 Configuration
Page 25 and 26: Configuration 25/65 5. Connecting t
Page 27 and 28: Configuration 27/65 Step 3: Enter t
Page 29 and 30: Configuration 29/65 Step 4C: ‣ Se
Page 31 and 32: Configuration 31/65 Figure 13: Wind
Page 33 and 34: Configuration 33/65 Step 5C: If nec
Page 35 and 36: Configuration 35/65 Step 6: Downloa
Page 37 and 38: Configuration 37/65 Step 8: Saving
Page 39 and 40: Configuration 39/65 6.3.2 Ethernet
Page 41 and 42: Configuration 41/65 • Minimum Sta
Page 43 and 44: Configuration 43/65 The device NL50
Page 45 and 46: Configuration 45/65 Figure 28: Wind
Page 47 and 48: Troubleshooting 47/65 7 Troubleshoo
Page 49: Troubleshooting 49/65 7.2 Failure i
Page 53 and 54: Device Drawings and Connections 53/
Page 55 and 56: LED 55/65 LED-Display Status netLIN
Page 57 and 58: Technical Data 57/65 NL 50-MPI Para
Page 59 and 60: Error Numbers 59/65 12 Error Number
Page 61 and 62: Error Numbers 61/65 Error Number De
Page 63 and 64: Lists 63/65 14 Lists 14.1 List of F
Page 65: Contacts 65/65 15 Contacts Headquar

netLINK NL 50-MPI

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?