OPERATING MANUAL - Bad Request

For incubators with O 2 module:
► Attach the supplied CO 2 pressure hose
to the CO 2 gas bottle (pressure reducer)
and to the “CO2 In” connection on the
rear of the incubator with a hose clamp
( Fig. 13 , see also page 13 ).
► Attach (push on) the supplied N 2 pressure
hose to the N 2 gas bottle (pressure
reducer) and to the “N2 In” connection
on the rear of the incubator with a hose
clamp.
4.3 Oxygen calibration
(only for models with O 2 module)
Perform an O 2 calibration before putting
into operation (see page 56 ).
Putting into Operation
„CO 2 In“
„N 2 In“
CO 2
Fig. 13
Gas connection for incubators with O 2 module
N 2
25