OPERATING MANUAL - Bad Request

Operation and control
5.10.2 Settings example normal mode
With a 5% CO 2 content, a 3% oxygen content and a humidity of 96%, the appliance should
heat up to 37°C. The monitoring function should respond at 38.5 °C ( Fig. 20 ).
Temperature in °C
50
40
30
20
10
Monitoring temperature
Humidity rh in %
Fig. 20 Example for normal mode
100
80
60
40
20
CO 2 in %
15
10
5
Time Time Time
1. Setting the normal operating mode:
Hold SET key down for approx. 3 seconds, the current
operating mode then begins to flash.
Select the operating mode with the push-turn control,
while the SET key is held down. After you let go of
the SET key, the control is in the normal operating mode.
2. Setting the temperature setpoint:
Hold down the SET key and set the desired temperature
setpoint of 37.0 °C with the push-turn control.
Release the SET key, the appliance will briefly flash, showing
the temperature setpoint. Then the current temperature
appears on the display and the controller begins to move
to the set temperature of 37.0 °C.
► Heating up is indicated by the icon.
3. Setting the monitoring temperature:
Turn the push-turn control to the right until the monitoring
temperature and the MIN or MAX icon flashes. Hold
down the SET key and with the push-turn control, set
the overtemperature limit to 38.5 °C and the undertemperature
limit to 36.0 °C. Turn the push-turn control to
the right until the monitoring temperature and the AUTO
icons flash. Hold down the SET key and set to on with the
push-turn control.
The tolerance band is set in the SETUP menu (see
page 45 ).
25
20
MIN
O 2 in %
25
20
15
10
5
AUTO
Time
PRINT SETUP
MAX
°C
°C
31