Tamarin marine paints ltd. - Tambour Paints
Tamarin marine paints ltd. - Tambour Paints
Tamarin marine paints ltd. - Tambour Paints
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Surface Preparation:<br />
New steel – Remove oil and grease with suitable detergent. Remove salt and other<br />
contamination by high pressure – fresh water cleaning. Blast in accordance with SA 2.5<br />
SIS 05 5900 – 1967 or ISO 8501-1. Blast to achieve a 25 to 50 mic profiles as determined<br />
with a Kean Tator Surface Profile Comparator. Remove abrasive residues and dust from<br />
surface. Apply as soon as possible after surface preparation to prevent any contamination.<br />
Maintenance – Remove oil and grease with suitable detergent. Remove salt and other<br />
contaminations by high pressure – fresh water cleaning. Remove rust and loose material<br />
preferably by dry abrasive blasting. Feather edges to sound and intact areas. Dust off<br />
residues. Touch up to full film thickness. Minor areas may be tool cleaning.<br />
Application Condition:<br />
Area should be clean and dry prior to application. Temperature should be above the dew<br />
point during application.. All areas difficult to cover properly by spray application should<br />
be stripe coated with a brush, immediately before spray application. Stir thoroughly with a<br />
mixer to a homogeneous condition. If necessary add up to 5% Thinner 4-100.<br />
Storage and Packing:<br />
Store in cool and dry condition.<br />
Packing: 20 Ltr.<br />
Remarks:<br />
This product will not cure adequately below 5 0 C.<br />
* If the maximum recoating interval is exceeded, roughening of the surface is necessary,<br />
to ensure intercoat adhesion. Before recoating, after exposure to contaminated<br />
environment, clean surface by high pressure fresh water. Allow to dry.<br />
The numerical information quoted in the data sheet is subject to normal manufacturing<br />
tolerances. Practical covering can vary depending on application conditions, structure and<br />
weather conditions. The volume solids figure is the percentage of dry film obtained from a<br />
given wet film thickness under specified application rate and conditions.<br />
The interval given assume preparation consistent with good painting practice.<br />
Safety Precautions:<br />
Refer to P.P.A. 2/1. Before and during use observe all safety labels on packaging and<br />
paint containers. Consult <strong>Tamarin</strong> Material Safety Data Sheet. Avoid direct contact with<br />
skin and eyes. (Gloves, goggles, face mask, barrier cream, etc.) Provide adequate<br />
ventilation If product comes in contact with skin wash with warm water and soak. If eyes<br />
are contaminated flush with water for 10 minutes and obtain medical attention.<br />
Basic Safety Precautions:<br />
This product contains flammable materials. Keep away from sparks<br />
and open flames. No smoking should be permitted in the area. Observe all precautionary<br />
notices on containers. Additional safety information is available on request.<br />
The information in this data sheet is given in good faith and to the best of our knowledge.<br />
It is subject to revision from time to time, in light of experience and our policy of continues<br />
product development. Since condition of application and service may be beyond our<br />
control, no liability can be accepted on basis of this data.<br />
31