User's Guide Command Line Interface - QLogic

3–Network Configuration
Configuring the Ethernet Port
IP Version 6 Configuration
The switch supports IP version 6, which includes the following:
• Network discovery method
• IP address
• IP gateway address
The network discovery method determines how the switch acquires its IP address.
The IP address can come from the IP address (static) that resides on the switch,
from a DHCP server, or it can be learned from a router through the Neighbor
Discovery Protocol (NDP). To configure the IP version 6 parameters, enter the
Set Setup System Ipv6 command:
SANbox (admin) #> set setup system ipv6
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
EthIPv6NetworkEnable
EthIPv6Discovery
EthIPv6NetworkAddress
EthIPv6GatewayAddress
False
Static
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
EthIPv6NetworkEnable (True / False) :
EthIPv6Discovery (1=Static, 2=Dhcpv6, 3=Ndp) :
EthIPv6NetworkAddress (IPv6 Address/Mask Length format) :
EthIPv6GatewayAddress (IPv6 Address) :
Do you want to save and activate this system setup? (y/n): [n]
DNS Server Configuration
A DNS server manages the host names for a fabric. This enables you to specify
servers and switches by a meaningful name rather than IP address. To configure
a DNS server, enter the Set Setup System Dns command in an Admin session as
shown in the following example:
SANbox (admin) #> set setup system dns
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
3-4 59263-02 B