LFS Cable routing systems - OBO Bettermann

Mounting aid for LKM metal cable trunking
Planning aid, LKM
Machines application area
In the area of machines, the LKM metal cable
trunking is used to provide additional protection
for the cables.
Corridor, stairwell application area
The stable LKM metal cable trunking can be
used anywhere, in which cables require mechanical
protection.
Machine trunking mounting
Screw the LKM metal cable trunking to the machine,
for example, using cylinder head bolts of
type 341.
Wall trunking mounting
Knock-in anchors of type 910/SD can be used
to fasten the LKM trunking directly on the wall.
Installation of internal corner
As with the LKM trunking, the fittings are mounted
at the appropriate points.
Installation of joint connectors
After installing the LKM trunking, lock the joint
connector into the parts to be connected from
inside. This guarantees the equipotential bonding
between these two parts.
Installation of partition
Insert the partition into the straps located on
the floor. This guarantees equipotential bonding
without any additional aids.
Installation of cable fixing holder
The cable bracket is mounted using the trunking
fastening screw. The cables can be held
using cable ties, type 555.
Installation of duct clamp
The duct clamp is placed on the loop perforation
in the base and then locked into the cover
contour. It can be placed at an offset. A partition
can be installed at a later time.
Equipotential bonding
Equipotential bonding is guaranteed between
the cover and the base through the special
cover contour. The LKM trunking is earthed using
the connection strap located in the base.
Installation of edge protection ring
Place the edge protection ring on the open
ends of the LKM trunking. It prevents damage
to the cables within.
Installation complete
The many fittings and accessories allow individual
installation designs.
06 LFS_Katalog_2010_Neuer_Stand / en / 25/02/2010 (LLExport_00995)
20 OBO LFS