LFS Cable routing systems - OBO Bettermann

Mounting aid, accessories Rapid 80 device installation trunking
Convector panelling, open at bottom
Often, convector panelling is planned in such a
way that it is not connected to the floor, in order
to aid room cleaning.
Convector panelling, closed at bottom
To ensure the continued circulation of the room
air, the connection to the floor should be made
with convection grids.
Panelling with convection grids
Convector panelling can also be fully created
using convection grids. The spaces between
the lamellae supports circulation and creates a
visually attractive solution.
Installation of wall bracket
The fastening holes for wall brackets are drawn
on the wall using a chalk mark. The maximum
panel spacing should be 600 mm.
Installation of stabilising profile
The stabilisation profile is required to install
GEK device installation trunking of trunking
height 213 mm. This is simply locked into the
front of the existing panels.
Installation of wall bracket
The holes for fastening the wall brackets are
drilled and the wall panels fastened to the walls
using bolts and anchors.
Installation of connection profile
When combined with the vertically aligned convection
grids or convector panelling, the appropriate
installation and connection profiles are
locked to the front of the fixing panels.
Installation of wall bracket
The height and depth of the wall panels are
aligned one after the other and then the panels
are locked.
Installation of connection profile
The mounting and connection profiles, type
6VG3/.., are required to install convection grid
profiles, type 6VV3/.. are required for closed
convector panelling.
Planning aid, device installation trunking accessories
06 LFS_Katalog_2010_Neuer_Stand / en / 25/02/2010 (LLExport_00995)
Installation of device installation trunking on
wall bracket
The GEK device installation trunking is mounted
on the wall racket and fastened using the
M5 fastening screws. This also creates a conductive
connection between the trunking and
the wall bracket.
Installation of profile connector
The profile connectors for horizontal convection
grids are attached to the wall brackets and
locked with the clamp.
Installation of spacings for convection grid
mounting
When mounting convection grids on the wall
panels, ensure that a maximum spacing of
150 mm is maintained between the end of
the grid lamella and the wall panels.
LFS
OBO
55