B-SX600 Series Supply Specification - Finn-ID
B-SX600 Series Supply Specification - Finn-ID
B-SX600 Series Supply Specification - Finn-ID
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
B-<strong>SX600</strong> <strong>Supply</strong> <strong>Specification</strong><br />
(2) Vertical (Feed Direction)<br />
Vertical misalignment due to repetition: B<br />
B = ±0.3 mm (When using the Transmissive<br />
Media Center Sensor)<br />
B = ±0.5 mm (When using other media<br />
sensor than the Transmissive Media<br />
Center Sensor)<br />
–direction<br />
B<br />
+ direction<br />
Paper feed<br />
direction<br />
(3) Variation among machines<br />
Variation among machines is ±1.0 mm in both horizontal and vertical directions, which<br />
can be adjusted by print position fine adjustment and X-coordinate fine adjustment<br />
(X ADJUST). For details, refer to the B-SA4T Key Operation <strong>Specification</strong> (RAA-2166).<br />
2.4.4 Accumulated Error<br />
• Misalignment of the vertical print position may become worse as the media comes closer to<br />
the end. The max. misalignment amount should be ±1% of the original coordinate under<br />
the above-mentioned print condition .<br />
• Small characters may be crushed due to local misalignment in the paper feed direction.<br />
This problem can be cleared by setting the printing speed to 2 ips or less.<br />
2.4.5 Suggestions for Designing Labels<br />
(1) Suggestions for Multiple-piece Labels<br />
To properly detect each label by the transmissive media sensor, the necessary detecting<br />
area that is specified in section 2.3.1 should be provided. At the same time, the shaded<br />
area shown below must be non-transmissive, excluding the necessary detecting area.<br />
Center of paper<br />
Label feed direction<br />
The sensor must be placed<br />
within this range.<br />
In order to detect a print start position of multiple-piece labels by using the transmissive media<br />
center sensor, a label row needs to be placed at the center of the backing paper. Generally,<br />
the Transmissive media center sensor can be used for multiple labels in odd rows.<br />
- 8 -