Shanks Owners manual (10 Build) 30, 30H, 35, 35H, 40 ... - EP Barrus

More documents

Recommendations

Info

SECTION 1 - Safety Precautions 1. General It is the responsibility of the installer/operator to ensure that the finished installation complies with the relevant health & safety requirements and the recreational craft directive before commissioning. Ensure that the engine battery isolator switch is in the off position and the key removed from the control panel before carrying out any maintenance or repairs. 2. Lifting The lifting points supplied with the engine are for lifting the engine/gearbox only. A suitable spreader bar must be employed to prevent over-stressing either bracket during any lift. 3. Rotating Shafts and Belts The engine and its accessories are not to be put into operation until they are integrated into the boat as a whole. No person should be in the engine compartment whilst the engine is running. 4. Exhaust System Exhaust gases may have temperatures as high as 600 o C and contain elements which are harmful if ingested. It is therefore essential that exhaust systems are gas tight and lagged to prevent accidental burning. 5. Launching and Lifting Boats Care must be taken when launching or craning new boats into or out of the waterway, so that water does not enter the engine via the exhaust system or air vents. It is recommended that these are blocked temporarily whilst undertaking this procedure. RDG6039484 Shanks10 Owners Manual Issue 1 Page 6 of 51
6. Batteries WARNING: EXPLOSIVE GASES / SULPHURIC ACID • Batteries can produce explosive gas; keep sparks and flames away from the battery. NO SMOKING • Batteries contain sulphuric acid; if splashed on skin or eyes, flush well with water and seek medical advice. • Keep the battery tops and battery compartment ventilated at all times. • If disconnecting the battery; remove the earth lead FIRST; and re-connect it last. • If charging the battery; ensure that the charger is switched off before connecting and disconnecting • Do not tip the battery on its side. • Please see label on battery or manufacturers instructions for specific information. RDG6039484 Shanks10 Owners Manual Issue 1 Page 7 of 51
Page 1 and 2: SHANKS CANAL BOAT ENGINE MANUAL For
Page 3 and 4: 5. Primary Fuel Filter Change .....
Page 5: PLEASE NOTE: This manual has been c
Page 9 and 10: SECTION 3 - Installation 1. Ventila
Page 11 and 12: engine, along with the 10mm packing
Page 13 and 14: 9. Engine Alignment • The gearbox
Page 15 and 16: pump lift pump (see Figure 11 page
Page 17 and 18: 14. Calorifier • The temperature
Page 19 and 20: • Visually check the engine for o
Page 21 and 22: Filler Cap Air Vent to Header Tank.
Page 23 and 24: element simply pulls out. • The a
Page 25 and 26: 4. Primary Fuel Filter Water Drain
Page 27 and 28: • Clean up any spilt fuel and dry
Page 29 and 30: hand, to guide the new belt into th
Page 31 and 32: 15. Gearbox Hydraulic Oil Filter (S
Page 33 and 34: when observed from the front of the
Page 35 and 36: SECTION 6 - Service Schedule Specif
Page 37 and 38: SECTION 7 - Shanks Engine Specifica
Page 39 and 40: SECTION 8 - Wiring Diagrams Harness
Page 41 and 42: Panel Wiring Diagram RDG6039484 Sha
Page 43 and 44: SECTION 9 - General Arrangements Sh
Page 45 and 46: Shanks10 35 RDG6039484 Shanks10 Own
Page 47 and 48: Shanks10 40 RDG6039484 Shanks10 Own
Page 49 and 50: Shanks Instrument Panels Engine ove
Page 51: SECTION 11 - Shanks Service Parts E

Shanks Owners manual (10 Build) 30, 30H, 35, 35H, 40 ... - EP Barrus

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?