Cisco IOS Software Configuration Guide for Cisco Aironet Access ...

Configuring the Access Point to Provide DHCP Service
Chapter 5
Administering the Access Point
Use the no form of these commands to return to default settings.
This example shows how to configure the wireless device as a DHCP server, exclude a range of IP
address, and assign a default router:
AP# configure terminal
AP(config)# ip dhcp excluded-address 172.16.1.1 172.16.1.20
AP(config)# ip dhcp pool wishbone
AP(dhcp-config)# network 172.16.1.0 255.255.255.0
AP(dhcp-config)# lease 10
AP(dhcp-config)# default-router 172.16.1.1
AP(dhcp-config)# end
Monitoring and Maintaining the DHCP Server Access Point
Show Commands
These sections describe commands you can use to monitor and maintain the DHCP server access point:
• Show Commands, page 5-24
• Clear Commands, page 5-25
• Debug Command, page 5-25
In Exec mode, enter the commands in Table 5-2 to display information about the wireless device as
DHCP server.
Table 5-2
Show Commands for DHCP Server
Command
show ip dhcp conflict [ address ]
show ip dhcp database [ url ]
show ip dhcp server statistics
Purpose
Displays a list of all address conflicts recorded by
a specific DHCP Server. Enter the wireless
device’s IP address to show conflicts recorded by
the wireless device.
Displays recent activity on the DHCP database.
Note Use this command in privileged EXEC
mode.
Displays count information about server statistics
and messages sent and received.
5-24
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-8191-01