Cisco IOS Software Configuration Guide for Cisco Aironet Access ...

More documents

Recommendations

Info

Configuring Radio Management Chapter 12 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Figure 12-17 WDS/WNM General Setup Page Step 4 Step 5 Step 6 Check the Configure Wireless Network Manager check box. In the Wireless Network Manager IP Address field, enter the IP address of the WLSE device on your network. Click Apply. The WDS access point is configured to interact with your WLSE device. CLI Configuration Example This example shows the CLI commands that are equivalent to the steps listed in the “Configuring Radio Management” section on page 12-27: AP# configure terminal AP(config)# wlccp wnm ip address 192.250.0.5 AP(config)# end In this example, the WDS access point is enabled to interact with a WLSE device with the IP address 192.250.0.5. For complete descriptions of the commands used in this example, consult the Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges. 12-28 Cisco IOS Software Configuration Guide for Cisco Aironet Access Points OL-8191-01
Chapter 12 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services Configuring Access Points to Participate in WIDS Configuring Access Points to Participate in WIDS To participate in WIDS, access points must be configured to participate in WDS and in radio management. Follow the steps in the “Configuring Access Points to use the WDS Device” section on page 12-14 and in the “Configuring Radio Management” section on page 12-27 to configure the access point to participate in WDS and in radio management. Configuring the Access Point for Scanner Mode In scanner mode, the access point scans all of its channels for radio activity and reports the activity to the WDS device on your network. A scanner access point does not accept client associations. Beginning in privileged EXEC mode, follow these steps to set the access point radio network role to scanner: Command Purpose Step 1 configure terminal Enter global configuration mode. Step 2 interface dot11radio { 0 | 1 } Enter interface configuration mode for the radio interface. The 2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1. Step 3 station role scanner Set the access point role to scanner. Step 4 end Return to privileged EXEC mode. Configuring the Access Point for Monitor Mode When an access point is configured as a scanner it can also capture frames in monitor mode. In monitor mode, the access point captures 802.11 frames and forwards them to the WIDS engine on your network. The access point adds a 28-byte capture header to every 802.11 frame that it forwards, and the WIDS engine on your network uses the header information for analysis. The access point uses UDP packets to forward captured frames. Multiple captured frames can be combined into one UDP packet to conserve network bandwidth. In scanner mode the access point scans all channels for radio activity. However, in monitor mode the access point monitors only the channel for which the access point radio is configured. Note If your access point contains two radios, both radios must be configured for scanner mode before you can configure monitor mode on the interfaces. Beginning in privileged EXEC mode, follow these steps to configure the access point to capture and forward 802.11 frames: Command Purpose Step 1 configure terminal Enter global configuration mode. Step 2 interface dot11radio {0 | 1} Enter interface configuration mode for the radio interface. The 2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1. OL-8191-01 Cisco IOS Software Configuration Guide for Cisco Aironet Access Points 12-29
Page 1 and 2:
Cisco IOS Software Configuration Gu
Page 3 and 4:
CONTENTS Preface xix Audience xix P
Page 5 and 6:
Contents Opening the CLI with Secur
Page 7 and 8:
Contents Optional ARP Caching 5-26
Page 9 and 10:
Contents Guidelines for Using Multi
Page 11 and 12:
Contents Applying an EAP Profile to
Page 13 and 14:
Contents Assigning Names to VLANs 1
Page 15 and 16:
Contents Verifying Repeater Operati
Page 17 and 18:
Contents Displaying the Logging Con
Page 19 and 20:
Preface Audience This guide is for
Page 21 and 22:
Preface Conventions Appendix B, “
Page 23 and 24:
Preface Related Publications ¡Adve
Page 25 and 26:
Preface Documentation Feedback Cisc
Page 27 and 28:
Preface Obtaining Technical Assista
Page 29 and 30:
CHAPTER 1 Overview Cisco Aironet Ac
Page 31 and 32:
Chapter 1 Overview Features WLSM Su
Page 33 and 34:
Chapter 1 Overview Features VoWLAN
Page 35 and 36:
Chapter 1 Overview Features • Wi-
Page 37 and 38:
Chapter 1 Overview Management Optio
Page 39 and 40:
Chapter 1 Overview Network Configur
Page 41 and 42:
Chapter 1 Overview Network Configur
Page 43 and 44:
CHAPTER 2 Using the Web-Browser Int
Page 45 and 46:
Chapter 2 Using the Web-Browser Int
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
CHAPTER 3 Using the Command-Line In
Page 59 and 60:
Chapter 3 Using the Command-Line In
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
CHAPTER 4 Configuring the Access Po
Page 69 and 70:
Chapter 4 Configuring the Access Po
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
CHAPTER 5 Administering the Access
Page 99 and 100:
Chapter 5 Administering the Access
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
CHAPTER 6 Configuring Radio Setting
Page 137 and 138:
Chapter 6 Configuring Radio Setting
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
CHAPTER 7 Configuring Multiple SSID
Page 173 and 174:
Chapter 7 Configuring Multiple SSID
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
CHAPTER 8 Configuring Spanning Tree
Page 187 and 188:
Chapter 8 Configuring Spanning Tree
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
CHAPTER 9 Configuring an Access Poi
Page 201 and 202:
Chapter 9 Configuring an Access Poi
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
CHAPTER 10 Configuring Cipher Suite
Page 211 and 212:
Chapter 10 Configuring Cipher Suite
Page 213 and 214:
Chapter 10 Configuring Cipher Suite
Page 215 and 216: Chapter 10 Configuring Cipher Suite
Page 217 and 218: CHAPTER 11 Configuring Authenticati
Page 219 and 220: Chapter 11 Configuring Authenticati
Page 239 and 240: CHAPTER 12 Configuring WDS, Fast Se
Page 241 and 242: Chapter 12 Configuring WDS, Fast Se
Page 265: Chapter 12 Configuring WDS, Fast Se
Page 271 and 272: CHAPTER 13 Configuring RADIUS and T
Page 273 and 274: Chapter 13 Configuring RADIUS and T
Page 299 and 300: CHAPTER 14 Configuring VLANs This c
Page 301 and 302: Chapter 14 Configuring VLANs Unders
Page 303 and 304: Chapter 14 Configuring VLANs Config
Page 309 and 310: Chapter 14 Configuring VLANs VLAN C
Page 311 and 312: Chapter 14 Configuring VLANs VLAN C
Page 313 and 314: CHAPTER 15 Configuring QoS This cha
Page 315 and 316: Chapter 15 Configuring QoS Understa
Page 317 and 318:
Chapter 15 Configuring QoS Configur
Page 319 and 320:
Page 321 and 322:
Page 323 and 324:
Page 325 and 326:
Page 327 and 328:
Chapter 15 Configuring QoS QoS Conf
Page 329 and 330:
CHAPTER 16 Configuring Filters This
Page 331 and 332:
Chapter 16 Configuring Filters Conf
Page 333 and 334:
Page 335 and 336:
Page 337 and 338:
Page 339 and 340:
Page 341 and 342:
Page 343 and 344:
CHAPTER 17 Configuring CDP This cha
Page 345 and 346:
Chapter 17 Configuring CDP Configur
Page 347 and 348:
Chapter 17 Configuring CDP Monitori
Page 349 and 350:
Chapter 17 Configuring CDP Monitori
Page 351 and 352:
CHAPTER 18 Configuring SNMP This ch
Page 353 and 354:
Chapter 18 Configuring SNMP Underst
Page 355 and 356:
Chapter 18 Configuring SNMP Configu
Page 357 and 358:
Page 359 and 360:
Page 361 and 362:
Page 363 and 364:
CHAPTER 19 Configuring Repeater and
Page 365 and 366:
Chapter 19 Configuring Repeater and
Page 367 and 368:
Page 369 and 370:
Page 371 and 372:
Page 373 and 374:
Page 375 and 376:
SP ED LED 1 5 2 6 3 7 4 8 1X 2X ETH
Page 377 and 378:
Page 379 and 380:
20 CHAPTER Managing Firmware and Co
Page 381 and 382:
Chapter 20 Managing Firmware and Co
Page 383 and 384:
Page 385 and 386:
Page 387 and 388:
Page 389 and 390:
Page 391 and 392:
Page 393 and 394:
Page 395 and 396:
Page 397 and 398:
Page 399 and 400:
Page 401 and 402:
Page 403 and 404:
Page 405 and 406:
Page 407 and 408:
Page 409 and 410:
Page 411 and 412:
Page 413 and 414:
21 CHAPTER Configuring System Messa
Page 415 and 416:
Chapter 21 Configuring System Messa
Page 417 and 418:
Page 419 and 420:
Page 421 and 422:
Page 423 and 424:
Page 425 and 426:
22 CHAPTER Troubleshooting This cha
Page 427 and 428:
Chapter 22 Troubleshooting Checking
Page 429 and 430:
Page 431 and 432:
Page 433 and 434:
Page 435 and 436:
Page 437 and 438:
Page 439 and 440:
Page 441 and 442:
Chapter 22 Troubleshooting Resettin
Page 443 and 444:
Chapter 22 Troubleshooting Reloadin
Page 445 and 446:
Page 447 and 448:
Page 449 and 450:
APPENDIX A Protocol Filters The tab
Page 451 and 452:
Appendix A Protocol Filters Table A
Page 453 and 454:
Appendix A Protocol Filters Table A
Page 455 and 456:
APPENDIX B Supported MIBs This appe
Page 457 and 458:
APPENDIX C Error and Event Messages
Page 459 and 460:
Appendix C Error and Event Messages
Page 461 and 462:
Page 463 and 464:
Page 465 and 466:
Page 467 and 468:
Page 469 and 470:
Page 471 and 472:
Page 473 and 474:
Page 475 and 476:
Page 477 and 478:
Page 479 and 480:
GLOSSARY 802.11 The IEEE standard t
Page 481 and 482:
Glossary dipole domain name DNS DSS
Page 483 and 484:
Glossary roaming RP-TNC A feature o
Page 485 and 486:
INDEX Numerics 1130AG series indica
Page 487 and 488:
Index Telnet 4-9 terminal emulator
Page 489 and 490:
Index reasons for 20-18 using FTP 2
Page 491 and 492:
Index IP redirection 7-11, 7-12 IPS
Page 493 and 494:
Index protected ports 6-25 protocol
Page 495 and 496:
Index server groups 18-7 shutdown m
Page 497 and 498:
Index tftp_init command 22-21 TFTP
show all

Cisco IOS Software Configuration Guide for Cisco Aironet Access ...

Create successful ePaper yourself

Delete template?

Save as template?