Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

More documents

Recommendations

Info

Remove the orange cable from the hard drive by pulling the cable straight up as shown. Do not use excessive force or you will bend the connector pins. Replacement note – If it is difficult to put the hard drive back in, you can remove the torx screw from the rib frame and move that portion of the rib frame slightly to allow for more wiggle room. Page 14 of 44 Copyright © 2004 <strong>Powerbook</strong>medic.com. All rights reserved.
CD / DVD Drive Removal Before proceeding, you must first remove: Battery Keyboard Bottom Case Remove the black dust cover as shown by gently prying up one corner and pulling up lightly. Work your way around the dust cover until it is free. (Do not pull too hard or you will tear part of the plastic on the DVD drive. It is recommended that you replace the dust cover when reinstalling a new drive.) Turn the computer over and locate the DVD drive and two orange cables connected to the motherboard. You must first remove the orange strip of tape covering the cables. Then, undo the orange cable on the left from the motherboard as shown. Your fingernail or a flat head screwdriver will work. Page 15 of 44 Copyright © 2004 <strong>Powerbook</strong>medic.com. All rights reserved.
Page 1 and 2: Powerbook G4 Titanium 400/500 Repai
Page 3 and 4: Identifying the Powerbook G4 400/50
Page 5 and 6: Before proceeding with any repair,
Page 7 and 8: Memory (Ram) Removal Before proceed
Page 9 and 10: Bottom Case Removal Before proceedi
Page 11 and 12: Airport Card Removal / Installation
Page 13: Hard Drive Removal Before proceedin
Page 17 and 18: PMU Board Removal Before proceeding
Page 19 and 20: Pram Battery Removal Before proceed
Page 21 and 22: Locate the EMI clip as shown. Using
Page 23 and 24: Remove the orange piece of tape cov
Page 25 and 26: Gently pry the clutch covers off of
Page 27 and 28: Display Take Apart / Hinge Replacem
Page 29 and 30: Opening the Display On both sides o
Page 31 and 32: After you work your way around, it
Page 33 and 34: Hinge Replacement Note: Some of the
Page 35 and 36: Break Type # 2 With the second type
Page 37 and 38: Use a pair of needle nose pliers to
Page 39 and 40: Guide the hinge into place. Make su
Page 41 and 42: Rib Frame / Heat Exchange Removal B
Page 43 and 44: Inverter Board Removal Before proce

Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

Create successful ePaper yourself

Delete template?

Save as template?