Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

More documents

Recommendations

Info

PCMCIA Card Cage Replacement Before proceeding, you must first remove: Battery Keyboard Bottom Case Airport Card (If installed) Logic Board Remove the two torx T8 screws as shown. Then just lift the card cage out of the trackpad. Page 40 of 44 Copyright © 2004 <strong>Powerbook</strong>medic.com. All rights reserved.
Rib Frame / Heat Exchange Removal Before proceeding, you must first remove: Battery Keyboard Bottom Case Airport Card (If installed) Logic Board PCMCIA Card Cage Remove the 4 Torx T6 Screws near the ports as shown. Remove the 4 Torx T8 screws from the location shown. Page 41 of 44 Copyright © 2004 <strong>Powerbook</strong>medic.com. All rights reserved.
Page 1 and 2: Powerbook G4 Titanium 400/500 Repai
Page 3 and 4: Identifying the Powerbook G4 400/50
Page 5 and 6: Before proceeding with any repair,
Page 7 and 8: Memory (Ram) Removal Before proceed
Page 9 and 10: Bottom Case Removal Before proceedi
Page 11 and 12: Airport Card Removal / Installation
Page 13 and 14: Hard Drive Removal Before proceedin
Page 15 and 16: CD / DVD Drive Removal Before proce
Page 17 and 18: PMU Board Removal Before proceeding
Page 19 and 20: Pram Battery Removal Before proceed
Page 21 and 22: Locate the EMI clip as shown. Using
Page 23 and 24: Remove the orange piece of tape cov
Page 25 and 26: Gently pry the clutch covers off of
Page 27 and 28: Display Take Apart / Hinge Replacem
Page 29 and 30: Opening the Display On both sides o
Page 31 and 32: After you work your way around, it
Page 33 and 34: Hinge Replacement Note: Some of the
Page 35 and 36: Break Type # 2 With the second type
Page 37 and 38: Use a pair of needle nose pliers to
Page 39: Guide the hinge into place. Make su
Page 43 and 44: Inverter Board Removal Before proce

Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

Create successful ePaper yourself

Delete template?

Save as template?