Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

More documents

Recommendations

Info

Along the rib frame there are 4 small torx T8 screws as shown. Remove all 4 screws. Gently lift the rib frame and heat sync up and out. Page 42 of 44 Copyright © 2004 <strong>Powerbook</strong>medic.com. All rights reserved.
Inverter Board Removal Before proceeding, you must first remove: Battery Keyboard Bottom Case Airport Card (If installed) Logic Board PCMCIA Card Cage Rib Frame / Heat Exchanger Fold the inverter board over and undo the orange connector as shown. The board will now be free to be removed. Page 43 of 44 Copyright © 2004 <strong>Powerbook</strong>medic.com. All rights reserved.
Page 1 and 2: Powerbook G4 Titanium 400/500 Repai
Page 3 and 4: Identifying the Powerbook G4 400/50
Page 5 and 6: Before proceeding with any repair,
Page 7 and 8: Memory (Ram) Removal Before proceed
Page 9 and 10: Bottom Case Removal Before proceedi
Page 11 and 12: Airport Card Removal / Installation
Page 13 and 14: Hard Drive Removal Before proceedin
Page 15 and 16: CD / DVD Drive Removal Before proce
Page 17 and 18: PMU Board Removal Before proceeding
Page 19 and 20: Pram Battery Removal Before proceed
Page 21 and 22: Locate the EMI clip as shown. Using
Page 23 and 24: Remove the orange piece of tape cov
Page 25 and 26: Gently pry the clutch covers off of
Page 27 and 28: Display Take Apart / Hinge Replacem
Page 29 and 30: Opening the Display On both sides o
Page 31 and 32: After you work your way around, it
Page 33 and 34: Hinge Replacement Note: Some of the
Page 35 and 36: Break Type # 2 With the second type
Page 37 and 38: Use a pair of needle nose pliers to
Page 39 and 40: Guide the hinge into place. Make su
Page 41: Rib Frame / Heat Exchange Removal B

Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?