Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

More documents

Recommendations

Info

Grabbing the drive from the sides only, lift the drive up and out. Note –Grasp the drive by the sides only or you run the risk of damaging your drive. Page 16 of 44 Copyright © 2004 <strong>Powerbook</strong>medic.com. All rights reserved.
PMU Board Removal Before proceeding, you must first remove: Battery Keyboard Bottom Case CD/DVD Drive First, Remove all of the orange tape surrounding the PMU board. Then undo the two cables as shown. Your fingernail or a flathead screwdriver will work. Undo the red white and black cable as shown. Page 17 of 44 Copyright © 2004 <strong>Powerbook</strong>medic.com. All rights reserved.
Page 1 and 2: Powerbook G4 Titanium 400/500 Repai
Page 3 and 4: Identifying the Powerbook G4 400/50
Page 5 and 6: Before proceeding with any repair,
Page 7 and 8: Memory (Ram) Removal Before proceed
Page 9 and 10: Bottom Case Removal Before proceedi
Page 11 and 12: Airport Card Removal / Installation
Page 13 and 14: Hard Drive Removal Before proceedin
Page 15: CD / DVD Drive Removal Before proce
Page 19 and 20: Pram Battery Removal Before proceed
Page 21 and 22: Locate the EMI clip as shown. Using
Page 23 and 24: Remove the orange piece of tape cov
Page 25 and 26: Gently pry the clutch covers off of
Page 27 and 28: Display Take Apart / Hinge Replacem
Page 29 and 30: Opening the Display On both sides o
Page 31 and 32: After you work your way around, it
Page 33 and 34: Hinge Replacement Note: Some of the
Page 35 and 36: Break Type # 2 With the second type
Page 37 and 38: Use a pair of needle nose pliers to
Page 39 and 40: Guide the hinge into place. Make su
Page 41 and 42: Rib Frame / Heat Exchange Removal B
Page 43 and 44: Inverter Board Removal Before proce

Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?