Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

More documents

Recommendations

Info

On both sides of the casing is the piece shown in red. This piece pivots up and “folds” over. On the side with the display cable and white and blue wire, lift this piece up, and then, carefully guide the display cable and blue and white cable through the hole. You will have to turn the display data cable to get it properly go through the hole. Be very careful with the cables! Page 26 of 44 Copyright © 2004 Powerbookmedic.com. All rights reserved.
Display Take Apart / Hinge Replacement READ BEFORE PROCEEDING Working on the display of the G4 Titanium is a very risky procedure. If you are not careful, there is a high risk of damaging your display. Also, the casing will not look 100% cosmetically perfect many times after performing this repair if you have never done this type of work before. Physical Harm – The casing of the Display is extremely sharp, and you risk cutting yourself on the casing if you are not careful. We strongly recommend using protective gloves when performing this procedure. By performing any work on your Powerbook and by continuing with this repair, you agree that Powerbookmedic.com is in no way shape or form responsible for any damage done to your laptop or for physical injury done to yourself. Before proceeding, you must first remove: Battery Keyboard Bottom Case Airport Card (If installed) Logic Board Display Hinge Mount Removal Hold your display as shown, and locate the 2 hinge mounts shown in red in the picture. They will be held on by two black Philips head screws Page 27 of 44 Copyright © 2004 Powerbookmedic.com. All rights reserved.
Page 1 and 2: Powerbook G4 Titanium 400/500 Repai
Page 3 and 4: Identifying the Powerbook G4 400/50
Page 5 and 6: Before proceeding with any repair,
Page 7 and 8: Memory (Ram) Removal Before proceed
Page 9 and 10: Bottom Case Removal Before proceedi
Page 11 and 12: Airport Card Removal / Installation
Page 13 and 14: Hard Drive Removal Before proceedin
Page 15 and 16: CD / DVD Drive Removal Before proce
Page 17 and 18: PMU Board Removal Before proceeding
Page 19 and 20: Pram Battery Removal Before proceed
Page 21 and 22: Locate the EMI clip as shown. Using
Page 23 and 24: Remove the orange piece of tape cov
Page 25: Gently pry the clutch covers off of
Page 29 and 30: Opening the Display On both sides o
Page 31 and 32: After you work your way around, it
Page 33 and 34: Hinge Replacement Note: Some of the
Page 35 and 36: Break Type # 2 With the second type
Page 37 and 38: Use a pair of needle nose pliers to
Page 39 and 40: Guide the hinge into place. Make su
Page 41 and 42: Rib Frame / Heat Exchange Removal B
Page 43 and 44: Inverter Board Removal Before proce

Powerbook G4 Titanium 400/500 Repair Guide - Powerbook Medic

Create successful ePaper yourself

Delete template?

Save as template?